Analysis and Experiment of Metal-polymer Composite Microscopic Structure Molding

Li Xiping,Gong Ningning,Wang Bin,Yang Can

DOI: https://doi.org/10.3969/j.issn.1004-132X.2016.13.023

2016-01-01

Abstract:Based on the forming technology for the metal-polymer composite parts,a method to manufacture these products was proposed.By improving the temperature,microscopic structure of the metal surface,and the viscosity,pressure and other characteristics of the polymer melt,the metal-polymer composite parts might be directly manufactured by inj ection method.Three different methods were presented to form different kinds of microscopic structures on metal surface and the characteris-tics of the structures were also obtained.A temperature control system used to control the tempera-ture of the metal sheet was established in the laboratory.By using the control system and the manu-factured inj ection mold,the metal-polymer composite parts were molded.Experimental results show that the interface bonding strength between the metal and polymer is much higher than the strength of the inj ected polymer itself.Results obtained herein may promote this new engineering applications of the polymer resin inj ection bonding with the metal alloy technology.