Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process
Bikram K. Khandai,Shivam Shukla,Gopinath Muvvala
DOI: https://doi.org/10.1016/j.jmapro.2024.04.012
IF: 5.684
2024-04-18
Journal of Manufacturing Processes
Abstract:Laser forming is an advanced metal forming technique that uses the energy from high-power laser to permanently deform the components by inducing localized thermal stresses. One of the major challenges in laser forming is attaining a targeted bending angle. Unlike the conventional processes, the targeted angle in the case of laser forming has to be achieved through multiple laser scans. However, due to strain hardening, heat accumulation and sheet thickening near the processing zone, the bending angle per scan keeps on varying, making it difficult to achieve the desired angle. In order to overcome these limitations as well as to automate the process, the current study aims to develop a real-time monitoring setup and investigate the bending mechanism based on real-time detection of temperature gradients and bending angle with the scan number. This was achieved through two non-contact type IR pyrometers, one focused on the top and the other on the bottom surface of the sheet being bent, monitoring the temperature gradient. Real-time bending of the sheet as the laser beam scans it was captured using a non-contact type displacement sensor. Further, the study investigates the effect of process parameters, i.e., laser power and scan speed, on the bending angle. Also, the effect of inter-pass delay and its effect on bending angle was investigated. Among laser power and scanning speed, laser power has a higher effect on the bending angle. Also, it was observed that higher-thickness sheets exhibit lesser bending angles due to higher section modulus. Further, inter-pass cooling is also found to affect the bending angle significantly as it mitigates the heat accumulation effect, thereby strain hardening dominating the bending angle achieved per pass leading to a reduced bending angle.
engineering, manufacturing