Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

Analysis of Friction Coefficient in Sliding Model of Double Rough Surfaces

Sliding State Analysis of Fractal Rough Interface Based on the Finite Element Method

Prediction of Sliding Friction Force of Rough Surfaces in Lubricated Point Contacts

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

Shear characteristics of interface based on subloading-friction model

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

A computer model for sliding friction in lubricated-point contacts

Analytically decoupling of friction coefficient between mixed lubricated fractal surfaces

2D Numerical Model for Studying Frictional Sliding

Modelling tangential friction considering contact pressure distribution of rough surfaces

Mechanism Analysis and Improved Model for Stick-Slip Friction Behavior Considering Stress Distribution Variation of Interface

A Bi-Gaussian Acoustic Emission Model for Sliding Friction

A friction model of fractal rough surfaces accounting for size dependence at nanoscale

Modeling of Frictional Stick-Slip of Contact Interfaces Considering Normal Fractal Contact

Analysis of the Rolling Interface Contact Characteristics in Mixed Lubrication Based on Gaussian Distribution Theory

Finite element analysis of fretting wear considering variable coefficient of friction

Modelling for Water-Based Liquid Lubrication with Ultra-Low Friction Coefficient in Rough Surface Point Contact

A Simulation Method of Thermo-Mechanical and Tribological Coupled Analysis in Dry Sliding Systems

Micro Sliding Friction Model Considering Periodic Variation Stress Distribution of Contact Surface and Experimental Verification