Abstract:Water lubricated stern bearings (WLSBs) are the critical component of ship propulsion system and have important effect on navigation safety. Operating temperature plays a main role on the performance of WLSBs. This paper aims to investigate the effect of operating conditions on bearing temperature characteristics under hydrodynamic lubrication. A novel CFD simulation method developed to improve calculation accuracy. Finite difference method was used to decrease the error of geometric modeling while the experiment and experimental correction formula were exploited to obtain improved boundary conditions. Based on the new method, the effects of operating conditions on temperature characteristics for two typical WLSBs were studied, and mechanisms of bearing temperature field evolution were discussed. Results show that the max friction coefficient appears when bearings are in low velocity and low load condition. Total heat flux density is a function of linear velocity, pressure and friction coefficient. Max temperature of bearing at 0.4 MPa decrease along with increased velocity, while decrease first and then increase at 0.2 MPa. Moreover, peak temperature appears at eccentric side and beyond minimum water film thickness position about 4–40°. High temperature area mainly located at the position of 80–140° in circumferential direction and 0.2–0.13 m in axial direction. With the increase of inlet water velocity, the max temperature of bearing changes slightly. It is appropriate to set the inlet velocity at 2 m/s to obtain better cooling performance. This work can provide theoretical basis for the operation monitoring of WLSBs and the development of new materials.

Effects of Water Contamination on Thermal Elastohydrodynamic Lubrication of Journal Bearing

Effects of Lubricant Viscosity-Temperature Relationship on the Capacity of Sliding Bearing

A Thermal Equilibrium Analysis of Line Contact Hydrodynamic Lubrication Considering the Influences of Reynolds Number, Load and Temperature

Effects of Surface Texture on Turbulent Lubrication of Water-lubricated Journal Bearing

Effects of Initial Conditions and Impact Load on Transient Lubrication Behavior of Journal Bearings

Effect of liquid contaminants on tribological performance of greases

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Effects of turbulence and bush wear on the transient tribo-dynamic characteristics of water-lubricated bearings

Investigation on the nonlinear dynamic behaviors of water-lubricated bearings considering mixed thermoelastohydrodynamic performances

Thermohydrodynamic Analysis of Journal Bearings Lubricated with Couple Stress Fluids

Experimental and Numerical Analysis of a Self-Circulating Oil Bearing System for Gear Pumps

Effects of Pad Face Thermal Distortion on Thermal Hydrodynamic Lubrication Performance of Multi-tilting-pad Journal Bearing

Effect of Free Water on Film Forming Characteristics of Lubricating Oil in Point Contact Zone

Analysis of Thermal Expansion Effects on Leakage in Self- sealed Journal Bearings

A novel approach to investigate temperature field evolution of water lubricated stern bearings (WLSBs) under hydrodynamic lubrication

Effect of Microcontent of Oil in Water under Confined Condition

Theoretical and experimental study on influences of surface texture on lubrication performance of a novel bearing

Composite thermal oil film lubrication model for hybrid journal bearings

Effects of Wear and Shaft-shape Error Defects on the Tribo-dynamic Response of Water-lubricated Bearings Under Propeller Disturbance

Transient Thermal Thermal Elastohydrodynamic Lubrication Performance of Multi-tilting-pad Journal Bearing

Simulation and Experimental on Thermal Behavior of Hydrostatic Thrust Bearing Based on Superhydrophobic/oleophobic Surface