Investigation of aerodynamic loss mechanism on turbine leading edge with slot film cooling based on entropy analysis
Jingyu Hu,Yanfeng Zhang,Jianshe Zhang,Miaoyi Zhu,Junqiang Zhu
DOI: https://doi.org/10.1016/j.ijthermalsci.2024.109386
IF: 4.779
2024-09-03
International Journal of Thermal Sciences
Abstract:Discrete film holes are a widely used cooling structure, with increasing cooling performance demands making their optimization increasingly complex. The structure of slot cooling is simpler compared to discrete holes, but it results in greater flow losses while improving cooling performance. To elucidate the sources and mechanisms of losses in slot cooling, this study employs numerical simulations based on the Reynolds-averaged Navier-Stokes (RANS) method. The investigation focuses on the leading-edge cooling of high-pressure turbine guide vanes, using entropy analysis to thoroughly examine the effects of blowing ratio (M) and slot spacing on loss location, composition, characteristics, and mechanisms. The results indicate that the losses associated with hole structures are not sensitive to changes in blowing ratio, while the entropy generation in slot structures generally increases with higher blowing ratios. Near the corner region, the traction effect of the horseshoe vortex expands the thermal loss region of the coolant, weakening the heat exchange in hole structures but significantly enhancing it in slot structures. The hole/slot structures have a minimal impact on the location of the passage vortex core, reducing the cross-flow velocity and cross-flow layer thickness. The greater flow losses are primarily due to increased passage vortex intensity. Slot cooling can achieve superior cooling performance at low M compared to hole structures at high M , with both having similar total pressure loss. However, the thermal losses for slot structures increase by approximately 55 % compared to hole structures on the pressure side of the leading edge, with even more significant increases on the suction side, while the maximum increase in viscous losses is only about 10 %.
engineering, mechanical,thermodynamics