Abstract:Rolling bodies in cageless ball bearings without cage control will always hit each other. This causes the rolling bodies to wear out faster and decreases the bearing's performance. But most of the available references only look at how well the bearing works when the cage is in place. They do not look at how the inner ring's dynamic response changes when the cage is removed and the rolling elements' motion changes. On the basis of this, a nonlinear rolling-body dynamics model with six degrees of freedom and contact between rolling bodies is suggested. The dynamics model of an automatic discrete system is built on the motion coupling and functional slot discrete theories. The power hardware re-turn method is used to figure out how to solve the dynamics model. The results show that after the rotor falls into the inner ring, the rolling bodies will cause cumulative collision for a short time. Then, because of the function slot, the occasional collision between the rolling bodies would not cause cumulative collision again, and the inner ring motion will be more stable. When the speed of the rotor's fall goes up, the rolling bodies hit each other more often. This makes the inner ring move more steadily, but there is a limit. To make sure that the theoretical analysis and the results of the theoretical solution are right, a high-speed camera was used. To make sure that the theoretical analysis and the results of the theoretical solution are right, we built a bearing test platform to take pictures of the rolling body of the bearing as it moved. The image processing program is used to figure out the rolling body's angular speed, compare the test results to the theoretical study and make sure that the theoretical study is right. The theoretical study is compared to the test results to see if the theoretical study is right.

Research on Structural Behavior of Needle Roller Components in Teasing Machine

Design Research on Roller of New Fiber Carding Machine

Vibration Analysis of High-speed Traction Elevator Based on Guide Roller-rail Contact Model

Influence of the Deformation of Riveting-Side Working Head on Riveting Quality

Model Analysis of Gilling Machine

The Finite Element Analysis on Can Coiler of Gilling Machine

A research of spinning machine: Effect of different structures of feed system on the static and dynamic characteristics

Analysis on Contact Strength of Needle Roller Bearing of Transmission and Effect of Surface Modification

Model for dynamic characteristics produced by inner race local defect in ball bearing system and its simulation

Finite Element Analysis of Dynamic Knitting Process on Flat Knitting Machine Based on ABAQUS

Analysis on Electromangentic Bearing Characteristics Based on ANSYS

Structures Dynamic Property Analysis of Elastic Composite Cylindrical Rolling Element

A Quasi-Dynamic Model for High-Speed Ball Spinning

Analysis on Contact of Needle Roller Bearings

ANALYSIS AND MODIFICATION OF HYDRAULIC ROLLER BENDING FORCE CONTROL SYSTEM

Finite Element Analysis of Roller Bearing Based on the Plastic Material Models

Needle’s vibration in needle-disk electrospinning process: Theoretical model and experimental verification

Research on multi-body dynamic model of automatic discrete system for protection bearing without cage

A review of static and dynamic analysis of ball screw feed drives, recirculating linear guideway, and ball screw

The Design and Simulation of Roller for Machining Involute Spline

Study on the vibration characteristics of deep groove ball bearings under time-varying loads