Abstract:The synchronal rotary compressor (SRC) has been developed to resolve high friction and severe wear that usually occur in conventional rotary compressors due to the high relative velocity between the key tribo-pairs. In this study, the working principle and structural characteristics of the SRC are presented first. Then, the kinematic and force models are established for the key components—cylinder, sliding vane, and rotor. The velocity, acceleration, and force equations with shaft rotation angle are derived for each component. Based on the established models, numerical simulations are performed for a SRC prototype. Moreover, experiments are conducted to verify the established models. The simulated results show that the average relative velocity between the rotor and the cylinder of the present compressor decreases by 80–82% compared with that of the conventional rotary compressors with the same size and operating parameters. Moreover, the average relative velocity between the sliding contact tribo-pairs of the SRC decreases by 93–94.3% compared with that of the conventional rotary compressors. In addition, the simulated results show that the stresses on the sliding vane are greater than those on the other components. The experimental results indicate that the wear of the side surface of the sliding vane is more severe than that of the other components. Therefore, special treatments are needed for the sliding vane in order to improve its reliability. These findings confirm that the new SRC has lower frictional losses and higher mechanical efficiency for its advanced structure and working principle.

Simulation on Structural Strength of the Double Vane Translational Rotary Compressor Based on ANSYS

Optimal Structural Design of Swing Double- vane Rotary Compressor

Finite element analysis and topology optimization of direct-drive compressor valve

The Force Analysis and Study of the Critical Speed for Sliding Vane of Translational Rotary Compressor

Dynamic modeling and characteristics analysis of sliding vane in a high-speed rotary compressor considering groove distribution and multi-body coupling

Strength Analysis Based on Coupling Stress of Turbo-Expander Rotor System

Fluid-structure interaction analysis and optimization study of suction valves in small refrigeration compressors

Dynamic Analysis and Calculation on Synchronal Rotary Compressor

Analysis, modeling and simulations of an innovative sliding vane rotary compressor with a rotating cylinder

Mathematical Simulation and Design Optimization of a Novel Swing Vane Compressor

Structural Optimal Design of a Swing Vane Compressor

Dynamic Model and Numerical Simulation for Synchronal Rotary Compressor

Dynamic analyses for the rotor-journal bearing system of a variable speed rotary compressor

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation

A Theoretical Study on the Novel Structure of Vane Compressor for High Efficiency

Research of Comprehensive Modeling of Two-Dimensional Vector Nozzle/Actuator Load/Turbofan Engine

Finite Element Analysis for Gate Rotor Shaft of Single Screw Compressor

Flow-Induced Vibratory Stress Prediction on Small Turbofan Engine Compressor Vanes Using Fluid-Structure Interaction Analyses

Geometric model and pressurization analysis on a novel sliding vane compressor with an asymmetrical cylinder profile

Research on Stall Mechanism Based on Vorticity Dynamics in a Single-Rotor Axial Compressor

Investigation in Vane Tip Profile of Rotary Vane Compressor