Abstract:The increasing demands on safety, emission and fuel consumption require more accurate control models of micro internal combustion swing engine（MICSE）. The objective of this paper is to investigate the constant speed control models of four-stroke MICSE. The operation principle of the four-stroke MICSE is presented based on the description of MICSE prototype. A two-level Petri net based hybrid model is proposed to model the four-stroke MICSE engine cycle. The Petri net subsystem at the upper level controls and synchronizes the four Petri net subsystems at the lower level. The continuous sub-models, including breathing dynamics of intake manifold, thermodynamics of the chamber and dynamics of the torque generation, are investigated and integrated with the discrete model in MATLAB Simulink. Through the comparison of experimental data and simulated DC voltage output, it is demonstrated that the hybrid model is valid for the four-stroke MICSE system. A nonlinear model is obtained from the cycle average data via the regression method, and it is linearized around a given nominal equilibrium point for the controller design. The feedback controller of the spark timing and valve duration timing is designed with a sequential loop closing design approach. The simulation of the sequential loop closure control design applied to the hybrid model is implemented in MATLAB. The simulation results show that the system is able to reach its desired operating point within 0.2 s, and the designed controller shows good MICSE engine performance with a constant speed. This paper presents the constant speed control models of four-stroke MICSE and carries out the simulation tests, the models and the simulation results can be used for further study on the precision control of four-stroke MICSE.

Study on Idling Speed Stability by Spark Advance Angle Controlling Based on CMAC

An Engineering-Effective Adaptive Model Algorithm Control (AMAC) and Simulation

Research on Control Method of PMSM Based on CMAC Neural Network

Engine Control Design Using Globally Linearizing Control and Sliding Mode

Optimal control of oil-gas switch process of CNG/diesel dual fuel engine

Starting Control Strategy and Experimental Study of CNG Engine

Adaptive and Learning Control for SI Engine Model With Uncertainties

Study of Multi-Time Ignition Improving Ignition Reliability of LPG-Fueled Engine

Nonlinear torque and air-to-fuel ratio control of spark ignition engines using neuro-sliding mode techniques

Combustion timing control of HCCI engine based on NNPC and Elman‐NN model under complex conditions

Study with Fuzzy Self-Turning PID Controller on Idle Speed Controlling of Automobile

Idle speed control of FSAE racing engines based on Mid-ranging ADRC

Turbo-shaft engine adaptive neural network control based on nonlinear state space equation

Adaptive Engine Optimisation Using NSGA-II and MODA Based on a Sub-Structured Artificial Neural Network

Effect of Ignition Advance Angle on Idle Performance of Hydrogen Fueled CNG Engine

Constant Speed Control of Four-stroke Micro Internal Combustion Swing Engine

Advanced gasoline engine misfire diagnostic method based on crankshaft speed multiple filtering

Acoustic emission-based intelligent identification of piston aero-engine ignition advance angle anomalies

New energy vehicle engine speed control method based on vehicle networking technology

Coordinated Nonlinear Speed Control Approach for SI Engine with Alternator Dynamic Performance Can Be Improved, for Vehicles with Spark-Ignition (SI) Engines and Alternators That Handle Heavy Electrical Loads, by Control Design Methods That Consider Both the Engine and the Alternator.

An investigation of optimum control of a spark ignition engine fueled by NG and hydrogen mixtures