Abstract:The smart diesel program requires the engine electronic control unit to consider additional parameters, such as altitude and climatic conditions, in the mapping calibration process. A specially designed environmental simulation cabin, which can simulate environmental conditions at any longitude and dimension, would allow dynamometer testing to be performed indoors. Considering its high cost, a three-dimensional (3D) computational fluid dynamics (CFD) is needed to guide and/or complement experimental researches. As a result, the main objective of this study was to establish a 3D RANS model (i.e., reasonable computational cost and running time) that can provide in-cylinder details and predict the efficiency of a 6V150 diesel engine under varied operating conditions. A sector mesh approach was employed, considering only the compression, combustion, and expansion periods from intake valve closing to exhaust valve opening. The results indicated that the model simulated cylinder pressure agreed well with the experimental data, with relative errors of less than 6% during the primary compression, combustion, and expansion. Further, the model predicted heat release phasing was inconsistent with the experimental results, with absolute errors of less than one crank angle degree for peak pressure location, CA50, and ignition delay. In addition, the multidimensional model captured the effects of environmental pressure and temperature on spray formation (i.e., the dominant phenomenological event). Moreover, the model reasonably reproduced the effects of engine control variables on performance and emissions. All these observations demonstrated the validity of the selection and calibration of geometry, chemistry, and submodels including turbulence, spray, heat transfer, combustion, etc. Overall, the model was deemed capable of predicting combustion characteristics under extreme conditions, including high-temperature, high-cold, and high-altitude environments, which can facilitate the development of smart engines.

Constant Speed Control of Four-stroke Micro Internal Combustion Swing Engine

Speed Control of PMLSM Based on Internal Model Control

Modeling and Analysis of Hydraulic Controlled Rotary Valve Excitation System

Modeling of Separate Meter in and Separate Meter out Control System

Engine Control Design Using Globally Linearizing Control and Sliding Mode

Mechatronic model and simulation of four-wheel Mecanum vehicle driven by BLDC

An Experimental Study on Engine Dynamics Model Based In-Cylinder Pressure Estimation

Real-time Control Oriented HCCI Engine Cycle-to-cycle Dynamic Modelling

Adaptive and Learning Control for SI Engine Model With Uncertainties

Simulation Of Separate Meter In And Separate Meter Out Control Of Electro Hydraulic Load Sensing System

Multidimensional Computational Fluid Dynamics Combustion Process Modeling of a 6V150 Diesel Engine

A Real-Time Control Oriented HCCI Combustion Model in 4-Stroke HCCI/SI GDI Engine and Model-Based Fast Calibration Development

Multiple Model Predictive Functional Control for Marine Diesel Engine

An Economic Nonlinear Model Predictive Control Strategy for SI Engines: Model-Based Design and Real-Time Experimental Validation

Cylinder-Specific Model-Based Control of Combustion Phasing for Multiple-Cylinder Diesel Engines Operating with High Dilution and Boost Levels

Modeling and Control of Combustion Phasing in Dual-Fuel Compression Ignition Engines

Performance Analysis of A 2-Stroke Micro Free-Piston Swing Engine

Design of an SI Engine Cold Start Controller based on Dynamic Coupling Analysis

Development of a Model-Based Coordinated Air-Fuel Controller for a 3.0 dm3 Diesel Engine and Its Assessment through Model-in-the-Loop

HCCI ENGINE MODELLING FOR THE PURPOSE OF CONTROL DEVELOPMENT

Crank Event Based Fuel Injection and Spark Ignition Timing Control Strategy for SI Engines