Abstract:There is no uniform performance test rule and standard calculation method for efficiency improvement of a system that utilizes waste heat from flue gas and it is mainly carried out through turbine parameters, without considering boiler system performance. Given the above problem, in this paper, the steam turbine, boiler and waste heat from the flue gas step-up utilization system are calculated by establishing a thermal model of ultra-supercritical secondary reheating 1000 MW unit. At the same time, unit design data and field performance test results are used for verification. Analysis comparing simulation outcomes with experimental data revealed that the discrepancies in the heat consumption rate per unit, the efficiency of the boiler, and the rate of coal consumption for power generation peaked at a marginal variance of 0.2%. The optimum operating parameters of the system for low-grade flue gas recovery in a cascading manner are obtained through variable operating condition calculations. The optimum value of high-pressure bypass feed-water flow rate is 52 kg/s at 970 MW operating condition. At the same time, the difference between high-pressure bypass effluent and high plus effluent temperatures should be controlled to be close to 0°C, and the optimal value of low-pressure bypass condensate flow rate is 53 kg/s. As the flow of flue gas in the bypass increases, the efficiency of heat exchange in the bypass economizer also increases, resulting in greater absorption of heat in the utilization apparatus for flue gas waste heat, leading to a more effective energy-saving outcome. However, it is necessary to regulate the temperature of both the primary and secondary air to levels that exceed the minimum requirements for the safe functioning of the coal mill.

The Improvement of Double Pressure Condenser Optimum Vacuum and Operation Optimization for 600MW Power Units

Circulating Efficiency Test of Domestic 600MW Units and Their Performance Optimization Analysis

Thermo-Economic Optimization of the Dual-Pressure Condenser for 700 °C Ultra-Supercritical Coal-Fired Power Plants

Influence of Water Ring Vacuum Pump Performance on 300 MW Unit Economy

Computational boundary improvement and performance optimization of the flue gas waste heat cascade utilization system of the ultra-supercritical 1000 MW generator set

Energy-Saving Optimization Study on 700°C Double Reheat Advanced Ultra-Supercritical Coal-Fired Power Generation System

Optimization Tests on Main Steam Pressure for 600-MW Air-Cooling Heat Supply Units

Operation Data Based Modelling And Optimization Of Thermal Power Units Under Full Working Conditions

Analysis of heating load distribution and operation optimization for 350MW high back pressure double extraction series units

Influence of the Working Water Temperature of Water-ring Vacuum Pumps on the Target of Optimal Operation of Circulating Water System

Thermodynamic System Optimization Research on 1 000 MW Deep Peak-regulating Unit

Operating Status and Energy-saving Reconstruction Analysis of 600MW Unit Condensate Pump

Optimization Analysis of Pure Low-temperature Waste Heat Power Generation System

Optimization to Power Boiler Furnace Performance Design Method

Optimization Research On The Power Boiler Furnace Performance Design Method

E103 OPTIMAL ANALYSIS OF PURE LOW-TEMPERATURE WASTE HEAT RECOVERY GENERATION SYSTEM BASED ON DESIGN(Power System-1)

A real-time monitoring model for heat consumption rate of steam turbine unit based on unit power

The Power Flow Method for Analysis and Optimization of Heat Recovery and Power Generation System

Study on a New Modeling Method for Primary Frequency Regulation of Ultra-Supercritical Thermal Power Units

Numerical Investigation on the Impact of Exergy Analysis and Structural Improvement in Power Plant Boiler through Co-Simulation

Experimental study and model optimization of thermodynamic performance of a single screw water vapor compressor