Abstract:Ice slurry is composed of ice particles and aqueous solution, and it can be utilized as cold storage medium and secondary refrigerant in a secondary-loop refrigeration. In the present study, the forced convective flow and heat transfer of ice slurry in horizontal pipes were numerically investigated, in which 3D Euler-Euler multiphase model based on kinetic theory of granular flow was adopted. The model was firstly validated with the experimental results from the literature. Thereafter, it was applied to investigate the flow and heat transfer characteristics of ice slurry under various conditions. The numerical results showed that more ice particles were suspended on the upper side of pipe at higher inlet velocity and solid volume fraction due to larger turbulent dispersion force and collision interaction among ice particles. During the flow melting process of ice slurry in a horizontal circular pipe under constant wall heat flux, the local heat transfer coefficient decreased rapidly in the entrance region, followed by an approximately constant value. However, when the solid volume fraction near the wall decreased to a small value, ice particles in the center region were difficult to be melted. Hence, the contribution of phase change to heat transfer decreased along the flow direction, resulting in decreasing local heat transfer coefficient. When the solid volume fraction near the wall decreased to zero, a solution region formed near the wall and it extended along the flow direction. Thus the heat from the wall caused rapid increase in the mean fluid temperature, resulting in increasing heat transfer coefficient. After ice slurry was fully melted into aqueous solution, the temperature increase of fluid resulted in decreasing viscosity and increasing turbulent intensity along the flow direction. Therefore, the heat transfer coefficient in the solution region continued increasing in the fully-melted region. (C) 2015 Elsevier Ltd. All rights reserved.

Simulation Investigation of Vertical Ice Layer Melting Characteristics under Forced Convection Heat Transfer

Numerical Analysis of Heat Transfer Behaviours of Melting Process for Ice Thermal Storage Based on Various Heat Source Configurations

Numerical Simulation of the Melting of Solid Particles in Thermal Convection with a Modified Immersed Boundary Method

Effect of natural convection on the internal-melt ice-on-tube with melting

Numerical Investigation on Heat Transfer and Melting Process of Ice with Different Porosities

A New Melting Model in Electrothermal De-Icing Simulation

Investigation of airflow thermal ice melting process under various flight conditions

Numerical Simulation On Heat Transfer Of Falling Film Flow Along A Vertical Wall

Thin liquid film flow and heat transfer under spray impingement

Experimental Validation and Tightly Coupled Numerical Simulation of Hot Air Anti-Icing System Based on an Extended Mass and Heat Transfer Model

Experimental investigation and scale analysis on melting of salty ice in a 3D-printed cavity filled with porous media

Melting of wall-mounted ice in shear flow

Thermo-fluidic Characteristics of Ice Slurry in Horizontal Circular Pipes

Simulation of Marangoni Effect on Falling Liquid Film Flow

Experimental Investigation on the Ice Melting Heat Transfer with a Steam Jet Impingement Method

Heat transfer in the melting of ice slurry during flow in a vertical slit channel

Lagrangian Simulation of Three-Dimensional Macro-Scale Melting Based on Enthalpy Method

Numerical Simulation of Ice Crystal Supercooled Droplet Mixed Phase Icing Based on the Improved Messinger Model

Experimental Study on the Thermal Conductivity for Transmission Line Icing

NUMERICAL INVESTIGATION OF THE HEAT AND MASS TRANSFER ON ANTI-ICING SURFACE

Study on flow and heat transfer characteristics of salt solution ice slurry