Abstract:Supported sorbent for flue gas desulfurization was prepared by a process of hydrating and drying a mixture of carrier particles and lumps of CaO in previous studies. Supported sorbent achieves high desulfurization efficiency in a Circulating Fluidized Bed (CFB) reactor at moderate temperature. However, the preparation process is complicated, which makes industrial application difficult. In this study, supported sorbent is prepared in situ in a CFB reactor by a coating process, in combination with SO2 removal. The experiments are conducted in a pilot-scale CFB experimental facility at 700-750 degrees C. The influence of operation parameters on supported sorbent formation and desulfurization efficiency is tested, including bed inventory, sprayer location, and spray method. The results show that the present process achieves 85.3% desulfurization efficiency with a Ca/S molar ratio of 2.01 when the bed inventory is 25 kg. This result is approximately 10 times higher than that of a zero bed inventory. The scanning electron microscope and energy dispersive spectrometer results show that the supported sorbent forms when fine Ca(OH)(2) particles in the lime slurry adhere to the bed material surface. The residence time of the supported sorbent in the CFB reactor is significantly longer than that of the fine Ca(OH)(2) particles. The adhesion efficiency is influenced by the spray location and spray method. The desulfurization performance of the supported sorbent prepared by the original hydration and drying method is also tested. The desulfurization efficiency is 25-35% higher than the present process because there is better adhesion in the original method than the in situ method. But the process complexity is significantly reduced when using the present process. The present process is a substantial attempt toward the application of supported sorbent.

Experimental Study on the Maximum Dispersion Rate of the Ca (OH) 2 Particles-Water Suspension Liquid for CFB-FGD Process

Optimization of CaO Particle Preparation and Performance Tests in a Bench Scale Circulating Fluidized Bed Reactor

Experimental Investigation of the Maximum CaO Particle Diameters in the Kinetic Zone for the Dry FGD Process

Experimental Study on the Reuse of Spent Rapidly Hydrated Sorbent for Circulating Fluidized Bed Flue Gas Desulfurization.

Experimental Study on in Situ Preparation of Supported Sorbent for Moderate Temperature CFB-FGD

Desulfurization Characteristics of Rapidly Hydrated Sorbents with Various Adhesive Carrier Particles for a Semidry CFB-FGD System.

STUDY ON THE PARTICLE SIZE OF Ca(OH)_2 IN SLURRY

EXPERIMENTAL STUDY ON THE EFFECT OF RE-CRYSTAL TO THE DRY FGD REACTION WITH CaO PARTICLES

Effect Of Potassium Sodium Tartrate And Sodium Citrate On The Preparation Of Alpha-Calcium Sulfate Hemihydrate From Flue Gas Desulfurization Gypsum In A Concentrated Electrolyte Solution

Experimental Study on the Preparation of Desulfurizer for Low Temperature Dry Desulfurization by Digesting CaO in Urea Solution

Novel Dry-Desulfurization Process Using Ca(OH)2/Fly Ash Sorbent in a Circulating Fluidized Bed

COMPARISON OF KINETIC REACTION RATE AND DIFFUSION RATE DURING DRY FGD REACTION WITH CAO PARTICLES

Study on desulfurization reaction characteristic of calcium-based sorbents

AN EXPERIMENTAL INVESTIGATION ON HUMIDIFIED ACTIVATION FLUE GAS DESULFURIZATION WITH HIGH CaO CONTENT FLY ASH

Experimental Study on Abrasion Characteristics of Rapidly Hydrated Sorbent for Moderate Temperature Dry Flue Gas Desulfurization

STUDY ON DESULFURIZATION CHARACTERISTIC IN CaO ACTIVATION REACTOR OF LIMESTONE INJECTION FGD SYSTEM --EXPERIMENTAL RESULTS AND DISCUSSION

Modeling Of The Aqueous Ca(Oh)(2) Reaction Under Semi-Dry Fgd Condition

Experimental Study on the Cfb-Fgd of Semi-Dry Process in A Demo Plant

Experimental Investigation on Disposal of the Product from a Slurry Jet WFGD

Structure Optimization Of Cfb Reactor For Moderate Temperature Fgd

Optimizing Flocculation–sedimentation for Regeneration of Dual‐alkali Flue Gas Desulphurization Scrubbing Solution