Abstract:Gallium nitride (GaN) high-electron-mobility transistor (HEMT) has the advantages of high switching speed and low ON-resistance, which make it widely used in high-frequency applications to realize high power density. Triangular current mode (TCM) modulation has been used in GaN-based converters to simultaneously achieve high power density and high efficiency through full-range zero voltage switching (ZVS). However, as switching frequency increases, the effect of dead time becomes more significant. Meanwhile, because of the junction capacitors of GaN HEMTs, the optimum dead time changes greatly with the turn-off current. Inappropriate dead time will induce extra loss that goes against the further improvement of power density. In order to minimize the dead-time loss in GaN HEMT-based TCM converter, this article proposes a strategy of adaptive dead-time control. An accurate turn-off transient model is proposed to calculate optimal dead time with consideration of the nonlinear capacitors. Based on this model, a loss model is established to evaluate the effect of dead time involving the short circuit in dead time. A new method of drive signal generation in TCM is proposed to increase the accuracy of dead-time control and reduce the current ripple. By reusing the detection signal in TCM, the adaptive dead-time control is realized without extra sensors. The proposed model is verified by a dual-pulse test, which shows the maximum error between the calculated and the experimental turn-off time is below 3 ns. The proposed adaptive dead-time control is implemented in a GaN HEMT-based boost converter. The experimental results show that the adaptive dead-time control can improve the efficiency over all operation conditions compared with using the fixed dead time, and the total loss is reduced by 26.7% at 800-W load and 70.8% at 50-W load.

Analysis of Dead-time Related Loss on GaN-based Synchronous Buck Converter

A 2mhz Constant-Frequency AOT V-2 Buck Converter with Adaptive Dead Time Control for Data Centers

A GaN-based MHz Active Clamp Flyback Converter with Adaptive Dual Edge Dead Time Modulation for AC-DC Adapters.

An Accurate Datasheet-Based Full-Characteristics Analytical Model of GaN HEMTs for Deadtime Optimization

A 2–10 MHz GaN HEMTs Half-Bridge Driver with Bandgap Reference Comparator Clamping and Dual Level Shifters for Automotive Applications

An Improved Analytical Model of GaN HEMT in Cascode Configuration During Turn-on Transition

A Buck Converter with Cost-Effective GaN/Si Hybrid Switches and CRM Operation for High-Efficiency and High-Power-Density Applications

A High Efficiency Model-Based Adaptive Dead-Time Control Method for GaN HEMTs Considering Nonlinear Junction Capacitors in Triangular Current Mode Operation

A High Frequency High Efficiency GaN Based Bi-Directional 48V/12V Converter with PCB Coupled Inductor for Mild Hybrid Vehicle

Optimal design of GaN HEMT based high efficiency LLC converter

Deadband Effect and Accurate ZVS Boundaries of GaN-Based Dual-Active-Bridge Converters With Multiple-Phase-Shift Control

A 1-Mhz ZVS Boost DC-DC Converter with Active Clamping Using GaN Power Transistors

A Unified Switch Loss Model and Design Consideration for Multilevel Boost PFC with GaN Devices

Modeling and Compensation for Dead-Time Effect in High Power IGBT/IGCT Converters with SHE-PWM Modulation

Virtual Prototype and GaN HEMT Based High Frequency LLC Converter Design

Factors and Considerations for Modeling Loss of a GaN-based Inverter

GaN Power Transistor Modeling for High-Speed Converter Circuit Design

Design of a Novel GaN-Based 4-Mhz ZVS Active-Clamping Synchronous Buck Converter

Optimization design of dead time in the four-switch buck-boost LLC resonant converter

Analysis and compensation of dead-time effect considering parasitic capacitance and ripple current

A Generic Power Loss Calculation Method for Fast Converter Performance Scanning