Abstract:<p>For photovoltaic modules, hot-spot phenomena are very common and influential, affecting device performance and causing irreversible damage. Researchers mainly pay attentions to hot-spot phenomena from a large-scale view that hot spots result from module failures, i.e., abnormal solar cells in photovoltaic modules are heated by other normal cells as loads. However, this heating process may not be the start of hot-spot phenomena. The large-scale hot-spot phenomena may develop from localized temperatures anomaly within a unit cell in the module while current researches generally ignored this small-scale but important problem. In this paper, close inspection of localized hot spots within photovoltaic modules is conducted with a xenon lamp of simulating the solar irradiation. An electronic load and an infrared thermal camera are utilized to detect and analyze electrical and thermal characteristics of the tested cells under different irradiation and surface conditions. With this experimental system, the localized hot-spot phenomena within a unit cell are experimentally revealed and the transient forming and variation processes of hot spots resulted from different mechanisms are explored, which are seldom reported to our knowledge. Attributed to localized hot spots, power conversion efficiency may fall to as low as 1.58% from 15.61%. In addition to the non-uniform irradiation, environmental obstructions falling on the cell surface may also form hot spots of very high temperature. Dust covering on the cell may lead to a hot spot above 64 °C, reducing cell efficiency by as much as 5.7 percent. The easily ignored localized hot-spot phenomena must be handled properly in case they get exacerbated and expand to the whole module.</p>

Study on fire risk of photovoltaic panels

Experimental Study on Burning Behaviors of Photovoltaic Panels with Different Coverings Using a Cone Calorimeter

Risk of photovoltaic systems on building fire safety in China

Hotspots and Performance Evaluation of Crystalline-Silicon and Thin-Film Photovoltaic Modules

Identifying PV Module Mismatch Faults by a Thermography-Based Temperature Distribution Analysis

A temperature-dependent fire risk assessment framework for solar photovoltaic station

Performance of photovoltaic panels with different inclinations under uniform thermal loading

Spread Behavior of Spill Fire under Lateral Wind and Temperature Distribution of PE Sandwich Panels on Facade

Impact of Sliding Window Opening Sizes and Crosswinds on Combustion Characteristics of Polyethylene Sandwich Panels in External Venting Façade Fires

Close examination of localized hot spots within photovoltaic modules

Study on Combustion Characteristics of Ceiling Materials Using Cone Calorimeter

Full-scale experimental study of the characteristics of electric vehicle fires process and response measures

Assessment on fire risk of lithium-ion battery packs with different sizes and states of charge by cone calorimeter

A Survey of Photovoltaic Panel Overlay and Fault Detection Methods

Effect of Width on the Fire Spreading Characteristics of PE Metal Sandwich Panels under the Action of Double Fire Sources

Fire Spread Characteristics of Metal-Polyethylene Sandwich Panels

Fire behavior of lithium-ion battery with different states of charge induced by high incident heat fluxes

Investigation on Lightning-Induced Voltage for Photovoltaic System Considering Electromagnetic Coupling of Rooftop Structure

Research on hot spot risk of high wattage solar modules

Experimental and simulation study on the combustion fire spreading characteristics of aluminum composite panels with different thicknesses

Experimental Study on Cross-ventilation Compartment Fire in the Wind Environment