Abstract:An aerodynamic optimization design process of multistage axial turbine is presented in this article: first, applying quasi-three dimensional (Q3D) design methods to conduct preliminary design and then adopting modern optimization design methods to implement multistage local optimization. Quasi-three dimensional (Q3D) design methods, which mainly refer to S2 flow surface direct problem calculation, adopt the S2 flow surface direct problem calculation program of Harbin Institute of Technology. Multistage local optimization adopts the software of Numeca/Design3D, which jointly adopts genetic algorithm and artificial neural network. The major principle of the methodology is that the successive design evaluation is performed by using an artificial neural network instead of a flow solver and the genetic algorithms may be used in an efficient way. Flow computation applies three-dimensional viscosity Navier?Stokes (N-S) equation solver. Such optimization process has three features: (ⅰ) local optimization based on aerodynamic performance of every cascade; (ⅱ) several times of optimizations being performed to every cascade; and (ⅲ) alternate use of coarse grid and fine grid. Such process was applied to optimize a three-stage axial turbine. During the optimization, blade shape and meridional channel were respectively optimized. Through optimization, the total efficiency increased 1.3% and total power increased 2.4% while total flow rate only slightly changed. Therefore, the total performance was improved and the design objective was achieved. The preliminary design makes use of quasi-three dimensional (Q3D) design methods to achieve most reasonable parameter distribution so as to preliminarily enhance total performance. Then total performance will be further improved by adopting multistage local optimization design. Thus the design objective will be successfully achieved without huge expenditure of manpower and calculation time. Therefore, such optimization design process may be efficiently applied to the aerodynamic design optimization of multistage axial turbine.

Investigation on Improving Aerodynamic Design Process of Blade in Turbomachine

Optimization Design of Centrifugal Fan Impeller Based on Numerical Simulation.

Flow Reconstructions and Aerodynamic Shape Optimization of Turbomachinery Blades by POD-based Hybrid Models

The Blade Shape Optimization of a Low-Pressure Axial Fan Using the Surrogate-Based Multi-Objective Optimization Method

Optimization Design of a Turbine Blade to Reduce Secondary Flow Loss Using a Viscous Adjoint Method

Aerodynamic Shape Optimization of a Transonic Fan by an Adjoint-Response Surface Method

Influence of Blade Lean Together with Blade Clocking on the Overall Aerodynamic Performance of a Multi-Stage Turbine

C207 applications of higher-order accurate computational fluid dynamic method to steam turbine blade designs

A STAGE OF TEST TURBINE DESIGN AND ITS FLOW FIELD ANALYSIS

Full 3-D Viscous Aerodynamic Optimization Design System for Turbomachinery

Study on Aerodynamic Optimization Design Process of Multistage Axial Turbine

Aerodynamic 3-Dimensional Optimal Design by NURBS of a Certain Stage Turbine Blades

3d Numerical Simulation Of Centrifugal Fan Inside Flow Field And Modification Investigation

Full 3-D Inverse Design Optimization Method for Turbomachinery Blade

Three-Dimensional Compressor Blading Design Improvements in Low-Speed Model Testing

Advanced Aerodynamic Optimization System for Turbomachinery

3D Numerical Investigation on the Aerodynamic Performance of an Air Cooled 4-Stage Turbine

Blade Design with Three-Dimensional Viscous Analysis and Hybrid Optimization Approach

Study on S2 Flow Path Design and Three-dimensional Numerical Simulation Parameter Calibration in Axial Compressor

AERODYNAMICS OPTIMUM DESIGN OF COMPRESSOR BLADES BASED ON NUMERICAL OVERALL PERFORMANCE CALCULATION

Aerodynamic Optimization System for Turbine Blade Design