Abstract:Significant achievements have been made in the last 60 years in the development of fusion energy with the tokamak configuration. Based on the accumulated knowledge, the world is embarking on the construction and operation of ITER (International Thermonuclear Experimental Reactor) with a production of 500 MWf fusion power and the demonstration of physics Q = 10. ITER will demonstrate D-T burn physics for a duration of a few hundred seconds to prepare for the next long-burn or steady state nuclear testing tokamak operating at much higher neutron fluence. With the evolution into a steady state nuclear device, such as the China Fusion Engineering Test Reactor (CFETR), it is necessary to examine the boundary conditions imposed by the combined development of tokamak physics, fusion materials and fusion technology for a reactor. The development of ferritic steel alloys as the structural material suitable for use at high neutron fluence leads to the use of helium as the most likely reactor coolant. This points to the fundamental technology limitation on the removal of chamber wall maximum heat flux at around 1 MW m(-2) and an average heat flux of 0.1 MW m(-2) for the next test reactor. Future reactor performance will then depend on the control of spatial and temporal edge heat flux peaking in order to increase the average heat flux to the chamber wall. With these severe material and technological limitations, system studies were used to scope out a few robust steady state synchronized fusion reactor (SFR) designs. As an example, a low fusion power design at 131.6 MWf, which can satisfy steady state design requirements, would have a major radius of 5.5 m and minor radius of 1.6 m. Such a design with even more advanced structural materials like W-f/W composite could allow higher performance and provide a net electrical production of 62 MWe. These can be incorporated into the CFETR program.

Lessons Learnt from ITER Nuclear Safety Licensing for CFETR

Recent Progress in Chinese Fusion Research Based on Superconducting Tokamak Configuration

Preliminary Study of the Status of Fusion Safety Regulation and Licensing

Safety Regulatory Framework for Hydrogen Fusion Reactors in China

Progress of ITER Procurement in China

Overview of the Present Progress and Activities on the Cfetr

Engineering design of the CFETR machine

Progress of the CFETR Design

A Preliminary Work on the Preparation for Neutron Irradiation of Advanced Fusion Materials Using Small Samples in China

Evaluation of CFETR as a Fusion Nuclear Science Facility using multiple system codes

Synchronized Fusion Development Considering Physics, Materials and Heat Transfer

Assessment on Safety Characteristics of Fusion Nuclear Reactor

Preliminary Neutronics Analyses of China Dual-Functional Lithium-Lead (DFLL) Test Blanket Module for CFETR

Lessons learnt from ITER safety & licensing for DEMO and future nuclear fusion facilities

Activation Calculation and Radiation Analysis for China Fusion Engineering Test Reactor

Phenomena Identification and Ranking Table for Thermal-Hydraulic Safety of China Fusion Engineering Test Reactor

Progress on Neutronic Analysis for CFETR

Progress of Concept Design for CFETR Diagnostic System

Development of System Code of Cfetr Design

Design Status of the ECRH System for CFETR