Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Experimental Study on Effects of Nanoparticles Deposition on Flow and Heat Transfer Characteristics of Nanofluid

Property of Water-Nanoparticle Flow and Heat Transfer in the Double-Tube Heat Exchanger with Nanofluid

Numerical investigation on the influence of particle deposition on nanofluid turbulent flow and heat transfer characteristics

Convective Heat Transfer and Resistance Characteristics of Nanofluids with Cylindrical Particles

Experimental Study on Aln/H2o and Al(2)O(3)/H2o Nanofluid Flow Boiling Heat Transfer and Its Influence Factors in A Vertical Tube

Pressure Drop and Heat Transfer of Nanofluid in Turbulent Pipe Flow Considering Particle Coagulation and Breakage

Experimental Study on Al2o3/H2o Nanofluid Flow Boiling Heat Transfer under Different Pressures

Analysis of the mechanism of enhanced heat transfer by nanofluids

Numerical Research on Convective Heat Transfer and Resistance Characteristics of Turbulent Duct Flow Containing Nanorod-Based Nanofluids

Experimental Study on the Convective Heat Transfer of Cuo-Water Nanofluid in A Turbulent Flow

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

Experimental study on cooling performance of nanofluid flow in a horizontal circular tube

Particle Distribution and Heat Transfer of SiO<sub>2</sub>/Water Nanofluid in the Turbulent Tube Flow

Experimental Investigation of nanofluid heat transfer in a square cross-sectional duct

Experimental investigations of effects of nanoparticle size on force convective heat transfer characteristics of Al 2 O 3 - MWCNT hybrid nanofluids in transitional flow regime

The Effects of Nanoparticle Aggregation on the Convection Heat Transfer Investigated by a Combined NDDM and DPM Method

Experimental study on heat transfer of nanofluids in a vertical tube at supercritical pressures

Experimental Investigation on Nanofluid Flow Boiling Heat Transfer in a Vertical Tube under Different Pressure Conditions

Experimental Study On Convection Heat Transfer Of Nanocolloidal Dispersion In A Turbulent Flow

Experimental Investigation of Al2O3/Water Nanofluid Through Equilateral Triangular Duct with Constant Wall Heat Flux in Laminar Flow

Effects of Nanoparticle Behaviors and Interfacial Characteristics on Subcooled Nucleate Pool Boiling over Microwire