Abstract:Direct contact condensation affects the performance of a small modular reactor with pressure suppression system. Since the heat and mass transfer varies with the condensation regimes as well as steam-water interface shapes, the identification and classification of the condensation regimes are important. The experiment of steam direct contact condensation was carried out and the corresponding condensation regimes were studied. Specifically, the experiment was studied by injecting steam vertically into a wet well with subcooled water. The physical process of steam condensation phenomenon with varying undercooling degree of wet well was recorded by high-speed camera. According to the location of the steam-water interface and the shape of the steam bubble, the four condensation regimes were studied, namely chugging, external necking, spheroidal upward bubble and T-shaped upward bubble. Besides, it is found that thermal stratification occurs in the wet well at low steam mass flux, the influence of each condensation regime on the thermal stratification of wet well was studied. The experimental results show that the internal chugging and external necking cause a large downward circulation of subcooled water, which enhance the flow mixing around the discharge tube and the bottom of the wet well. Consequently, the thermal stratification phenomenon does not happen in those condensation regimes. However, the regimes like spheroidal upward bubble and T-shaped upward bubble cause the upward circulation of subcooled water in wet well, which cause the thermal stratification. The critical Richardson number ( Ri ) determines the condensation regimes. Furthermore, when the Ri is smaller than 1, the condensation regime is external necking. Besides, when the Ri is greater than 1, the condensation regimes are spheroidal upward bubble and T-shaped upward bubble.

Direct Contact Condensation Characteristics Experiment Research in T-junction

Experiment Study on Temperature Fluctuation Characteristics of Two-phase Thermal Mixing in T-junction

Experiment Research on Thermal Mixing in Horizontal T-Junction: In-Pipe Temperature and Flow Characteristic Research

Numerical Study on Direct-Contact Condensation of Vapor in Cold Water

Experimental investigation on the effect of direct contact condensation regime on thermal stratification

Numerical Research on Thermal Mixing Characteristics in a 45-Degree T-junction for Two-Phase Stratified Flow During the Emergency Core Cooling Safety Injection

NUMERICAL INVESTIGATION ON DIRECT CONTACT CONDENSATION CHARACTERISTICS OF STEAM INJECTION INTO COLD-WATER PIPE UNDER HEAVING CONDITION

Experimental Research On Steam Condensation On Cold Surface: Facility Design

Steam Condensation on a Downward-Facing Plate in Presence of Air

Computational Fluid Dynamics Simulation Of Direct-Contact Condensation Phenomenon Of Vapor Jet In Subcooled Water Tank

Ecc Condensation Research in T-Junction

CFD Simulation of Direct Contact Condensation Phenomenon of Vapor Jet in Subcooled Water Tank

Effect of Non-Condensation Gas on Heat Transfer of Direct Contact Condensation

AN INVESTIGATION ON PWR REFLUX CONDENSATION CHARACTERISTICS

Theoretical Investigations On Water Condensation In Main Steam Pipe

Numerical investigations on the component separation phenomenon and transport behavior of steam-air-hydrogen mixture induced by condensation

Direct Contact Condensation Characteristics of Steam Injection into Cold-Water Pipe Under Rolling Condition

Experimental Observations of Thermal Mixing Characteristics in T-Junction Piping

Experiment investigation of a secondary PRHR cooling effect on an integral facility after a LOCA accident

Analysis Of Effects Of Buoyancy Force On Steam Condensation With Non-Condensable Gases In A Rectangular Channel

Experimental study on direct contact condensation of stable steam jet in water flow in a vertical pipe