Abstract:Vibration shaker testing is a great tool of validating the vibration fatigue performance of automotive components & systems. However, the representative vibration schedule requires a pre-knowledge of the acceleration history for the test object, which usually is not available until the later development phase of a vehicle program when physical properties are available. Sometimes, a generic vibration schedule developed from the worst-case loading profiles are used with risk of lacking correlation with later full vehicle durability test such as Road Test Simulator (RTS) or Proving Ground (PG) road test due to the higher loading amplitude. This paper proposes a virtual accelerometer approach to collect acceleration responses of a component from a virtual vehicle model. First, a multiple body dynamic model will be produced for virtual load calculation over a series of digitalized virtual proving ground road profiles. These loads will be then applied on the virtual vehicle CAE model with all representative components & subsystems. Acceleration response for the system of interest is then extracted from modal transient dynamic analysis. Later, the acceleration history is converted to frequency domain, and the associated spectral damage calculation is conducted. The final vibration profile is developed based on the equivalent damage concept. The virtual acceleration acquisition and physical acceleration acquisition show good agreement in both time domain and frequency domain. The profile generated from virtual acceleration acquisition covers very well for the physical acceleration acquisition. Overall, virtual acceleration-based profile ensures the conservative shake test results for the example studied. Compared to the physical accelerometer, the virtual accelerometer can provide acceleration data economically and quickly in the early phase of the product development. The proposed approach will ensure the component shaker test is conducted using the meaningful and representative vibration load.

Virtual Prototype Modeling and Design of Vibration Table with Wider Pulse for Particle Impact Noise Detection System

Research on Redress System of Vibration Table in Multi-Parameter Combined Environment Test System

Testing System of Characteristics of Electrical Vibration Table

Study on Fluid-Solid Coupling Dynamic Characteristics of Large Wide-Frequency-range Underwater Vibration Tables

Design and Implementation of Vibration Test Control System of Multi-Exciter Synchronization

Study on Electromechanical Coupling Characteristics of Electric Vibration Table in High-Translational-Acceleration

Research of the Testing System of Characteristics of Electrical Vibration Table Based on PSD

The Design of the Virtual Testing System of Vehicle Vibration Based on VR

The Transmission Characteristics and Influence Prediction of Impulsive Vibration Caused by a Solid Metal Ball Impact in Buildings

Virtual Accelerometer Approach to Create Vibration Profile for Automotive Component Shake Test

FEM Modeling of Vibro-Impact Response of Metal Plates Excited by a High-Power Ultrasonic Transducer

Dynamics Analysis of Vibration Process in Particle Impact Noise Detection

Research on Structural Dynamic Characteristics Based on Electromechanical Transfer Function Using Vibration Test Data

Inertial Type Piezoelectric Vibration Acceleration Control System Based on Virtual Instrument

Simulation and Characterization of Dynamic Contact in a MEMS Passive Vibration Threshold Sensor

Active Low-frequency Vertical Vibration Isolation System for Precision Measurements

Design, modeling and testing of a vibration absorption device with energy harvesting based on force amplifier and piezoelectric stack

Vibration Characteristic Analysis and Optimization of Heavy Load High Voltage Circuit Breaker Contact

Random response analysis based model validation and structural optimization of a vibration fixture

Theoretical modeling and experimental test for dynamic characteristics of an air-spring vibration isolation system

Research on the Equivalent Impact Test Method for Different Pulse Widths Based on Micro-Electro-Mechanical System Devices