Abstract:Beam oscillation in the laser welding process has demonstrated numerous advantages in suppressing spatters, eliminating pores, and reducing gap sensitivity, particularly for joining thin plates. This study presents the welding of thick section aluminum alloy using laser beam oscillation in a vacuum environment. During vacuum laser welding, the effect of beam oscillation variables, which include oscillating path, amplitude, and frequency, on weld seam morphology, microstructures, and mechanical properties was symmetrically evaluated. The findings indicate that in a vacuum environment, beam oscillation with a small amplitude can optimize the contour of the weld sidewall and increase the penetration depth, which is different from that observed in an atmospheric environment, where the melting penetration depth decreases with increasing oscillating amplitude. The deep penetration weld seam in a vacuum environment can achieve an extremely small size of 19 similar to 30 mu m. The addition of small oscillations causes a slight increase of the average grain size. The stirring effect of beam oscillation was weakened because of the minimized weld pool size under vacuum. This increased grain size is mainly attributed to the changes in the size of the molten pool caused by the oscillation cause changes in solidification parameters which accelerate grain growth. However, increasing the oscillation frequency can greatly increase the strength of the stirring effect and the refinement ability of small-sized grains. On further increasing the oscillation frequency to 200 Hz, the grown grains are refined. The results showed the tensile strength of the vacuum laser weld joints with and without beam oscillation can achieved a value of about 90 % of the base metal, which is superior to the strength of the joints welded by atmospheric pressure laser welding and can meet the vast majority of welding needs.

Study on Vacuum Welding Process of Slab Laser Module

A study on laser keyhole welding in vacuum by computational fluid dynamics simulations with plume effect models

Study on Fiber Laser Welding Process of Ultra-thin Metal Sheet

Process Stability and Parameters Optimization of Narrow-Gap Laser Vertical Welding with Hot Wire for Thick Stainless Steel in Nuclear Power Plant

Study on Process Stability and Seam Characteristics of High Power Laser Welding with Filling Wire for High Thickness Steel

Study of Molten Pool Dynamics and Porosity Formation Mechanism in Full Penetration Fiber Laser Welding of Al-alloy

Mitigation of Porosity Defects in Fiber Laser Welding under Low Vacuum

Research progress of laser welding under subatmospheric pressure

Visualization and simulation of 1700MS sheet laser welding based on three-dimensional geometries of weld pool and keyhole

Improving Thermal Efficiency and Stability of Laser Welding Process for Magnesium Alloy by Combining Power Modulation and Subatmospheric Pressure Environment

A study of welding process in connecting borosilicate glass by picosecond laser pulses based on response surface methodology

Laser Welding under Vacuum: A Review

Vacuum laser welding equipment and method

Numerical modeling and simulation for laser beam welding of ultrafine-grained aluminium

Effect of liquid column on process stability and weld formation under ultra-high power fiber laser-arc hybrid welding of thick plates

Numerical Study on Multiphase Evolution and Molten Pool Dynamics of Underwater Wet Laser Welding in Shallow Water Environment

Sensing and Control System of Process Quality in Co2 Laser Deep Penetration Welding

Numerical Simulation of Full Penetration Laser Welding of Thick Steel Plate with High Power High Brightness Laser

Characteristics of Bead Formation and Plasma Plume in Fiber Laser Welding Under Vacuum

Effect of Beam Oscillation on Weld Formation, Microstructure and Mechanical Properties in Vacuum Laser Beam Welding of Thick Section 5083 Aluminum Alloy

Numerical Simulation of the Laser Welding Process for Diamond Saw Blades