Abstract:Ca1−3x/2BixCu3Ti4O12 (x=0.0–0.3) ceramics were prepared by the conventional solid-state reaction method. X-ray powder diffraction analysis confirmed the formation of cubic CCTO phase except for subtle peaks of CuO. SEM micrographs suggested that the morphologies of doped CCTO ceramics had been sheet-like for high Bi-doping amount, and the dominant grain size decreasing could be seen for the small content of Bi-doping CCTO. Dielectric properties of pure and doped CCTO were investigated in a broad temperature range of 20–420K. The results showed that bismuth doping could decrease the dielectric loss but suppress the dielectric temperature stability at the same time. Bi doped CCTO ceramics presented different relaxation properties. As to pure CCTO and BCCTO (x=0.3) only one MW relaxation (Relaxation I) could be found, which moves to higher frequency with temperature increasing. However, two relaxation processes (Relaxation I and II) appear for BCCTO (x=0.1–0.2). By means of complex impedance spectra analysis and Arrhenius fitting, we successfully separated the different conductive segments and explained the mechanisms of the two relaxation processes. Relaxation I appeared at low temperature could be attributed to the VO doping energies inside CCTO grains which did not showed significant changing of activation energy after bismuth doping. For Relaxation II at higher temperature than Relaxation I, with activation energy obviously depending on the Bi-ion concentration, may be related with the VO point defects at the grain boundaries.

Preparation and Properties of B-site Zn2+ Substituted CaCu3 Ti4 O12 Ceramics

Enhancement of Giant Dielectric Response in CaCu3Ti4O12 Ceramics by Zn Substitution

Microstructure and Dielectric Properties of Ca1–3/2xBixCu3Ti4O12 (x = 0, 0.05, 0.10, 0.15 and 0.20) Ceramics

Electric and Dielectric Properties of Bi-doped CaCu3Ti4O12 Ceramics

Microstructure, dielectric and ferroelectric properties of CaCu3-xZnxTi4-xCexO12 ceramics prepared via semi-wet route

Structural and Dielectric Properties in the (ba1−ca )(ti0.95zr0.05)o3 Ceramics

Ti deficiency effect on the dielectric response of CaCu3Ti4O12 ceramics

Enhanced Dielectric and Ferroelectric Characteristics in Ca-Modified Batio3 Ceramics

Dielectric Properties of B-Doped Cacu3ti4o12 Ceramics

Preparation, Structure and Dielectric Properties of Catio3:Zn Ceramics Based on Sol-Gel Technology

Influence of zinc on electrical and microstructural properties of CaCu3Ti4O12 ceramics prepared by sol–gel process

Enhanced Performance of Core-Shell-like Structure Zr-doped CaCu3Ti4O12 Ceramics Prepared by a Flame Synthetic Approach

Dielectric Properties of Cacu3ti4o12 Ceramics Prepared by A Simplified Coprecipitation Method

The Study of Ca-doped BCTZ Ceramics Sintered in Reducing Atmosphere

Microstructure and Electrical Properties of Al<sub>2</sub>O<sub>3</sub>-Doped Ba<sub>0.9</sub>Ca<sub>0.1</sub>Ti<sub>0.8</sub>Zr<sub>0.2</sub>O<sub>3</sub> Based Dielectric Ceramics

Investigation and Characterization of Crystal Structure, Mechanical and Thermophysical Properties of CaZr4-xTixP6O24 Ceramics

Dielectric Properties of Bismuth Doped Cacu3ti4o12 Ceramics

Influence of zinc on electrical and microstructural properties of CaCu 3Ti 4O 12 ceramics prepared by sol-gel process

Effects of Zr Doping on the Microstructures and Dielectric Properties of CaCu3Ti4O12 Ceramics

Study of the Defect Chemistry of Ca-Doped Batio3 Ceramics

CaCu3Ti4O12 Ceramics from Basic Co-Precipitation (BCP) Method: Fabrication and Properties