Blending Modification of PLA Used for Fused Deposition Modeling

Junliang He,Dongcheng Sun,Yanxia Cao,Hualin Lai

DOI: https://doi.org/10.3969/j.issn.1001-3539.2017.06.002

2017-01-01

Abstract:Amide nucleating agent (NT-C) and polyethylene glycol 2000 (PEG2000) were used for modification of polylactic acid (PLA) by melt blending,then the PLA/NT-C/PEG2000 blends used for 3D printing were prepared. Print parts of the blends were prepared through fused deposition modeling (FDM) under 200 ℃ . The effects of NT-C contents on the crystallization prop-erties of PLA/NT-C print parts were studied,on this basis,the influences of PEG2000 contents on rheological properties of the blends,crystallization properties and mechanical properties of the blend print parts were studied. DSC analysis showes that NT-C can improve the crystallinity of PLA/NT-C print parts to some extent and the addition of PEG2000 with a certain contents can fur-ther improve the crystallinity,when the mass fraction of NT-C and PEG2000 is 2% and 5% respectively,the crystallinity reaches 17.1% and is improved by 12 times higher than PLA. The rheological properties tests show that PEG2000 improves the melt flow rate of the blend,the temperature dependency of the blend's storage modulus and loss modulus decreases,which broadens PLA 's molding temperature in the FDM processing. Mechanical properties tests show that the notched impact strength of the blend is sig-nificantly improved with addition of PEG2000,which reduces the risk of the interrupt silk when printing process,flexural and tensile strength of the blend print parts are also significantly improved compared with PLA,when adding 2% NT-C and 5% PEG2000,the flexural and tensile strength can reache more than 80% and 70% of those of injection parts separately,which broadens PLA's appli-cation in the FDM.