Abstract:Accumulation of electrostatic charges in gas–solid fluidized beds can lead to particle adhesions, electrostatic discharges, wall sheeting and even explosion. Therefore, it is of vital importance to reduce the electrostatic level in industrial fluidized beds. Adding chemical static agents was reported as one of the most promising ways to control fluidized bed electrostatic potentials. In this study, the electrostatic potential distributions were measured in a three-dimensional column gas–solid fluidized bed with the LLDPE particles for fluidization and the introduction of chemical static agents. Seven charge inducing agents including TiO2, Al2O3, MgO, H2O, C2H5OH, ZnO, and Fe2O3 were employed to investigate their influence on electrostatic potentials distribution respectively. Additionally, Al(Et)3, which is normally used as the cocatalyst for olefin polymerization, was also studied for comparison. It was found that the adding of negative charge inducing agent such as TiO2 made the positive electrostatic potentials shift to higher values and the negative electrostatic potentials shift to lower values. The injection of positive charge inducing agent such as Al2O3 and MgO caused the positive electrostatic potentials dropping to lower values and the negative electrostatic potentials shifting to the values near zero at low injection amount. Affecting mechanism of charge inducing agents was discussed based on the experimental results and the electronegativity of corresponding compounds. It was found that the electronegativity (χi) of the metal ion played an important role in determining the charge polarity on the LLDPE particles and the change in the electrostatic potentials after contact and separation with the charge inducing agent particles.

Flowability and anti-static properties of high impact polypropylene particles

Research Progress of Granular Flow and Fluidization Behavior of Coarse Cohesive Particles

Electrostatic Potentials in Gas–solid Fluidized Beds Influenced by the Injection of Charge Inducing Agents

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Electrostatic Effects on Hydrodynamics in the Riser of the Circulating Fluidized Bed for Polypropylene

Electrostatic Distribution in the Riser of the Multizone Circulating Fluidized Bed for Polypropylene

Effects of Agglomerates on Electrostatic Behaviors in Gas–solid Fluidized Beds

Effects of Interparticle Forces on Fluidization Characteristics in Liquid-Containing and High-Temperature Fluidized Beds

Investigation Of The Performance Of Fumed Silica As Flow Additive In Polyester Powder Coatings

Effect of polymer granules on the electrostatic behavior in gas-solid fluidized beds

Electrostatic behavior with fines of different sizes added into gas-solid fluidized bed

Study on Flowability Enhancement and Performance Testing of Ultrafine Dry Powder Fire Extinguishing Agents Based on Application Requirements

Experimental and Calculational Study on Effects of Flow Additive on Flowability of Fine Coating Particles

Enhanced Flowability and Film Properties of Ultrafine Powder Coatings Modulated by Modified Flow Additive

Investigation on Characterization of Powder Flowability Using Different Testing Methods

Validation of Surface Coating with Nanoparticles to Improve the Flowability of Fine Cohesive Powders

Improved Flowability of Ultrafine, Cohesive Glass Particles by Surface Modification Using Hydrophobic Silanes

Study on the effect of nanoparticles on the bulk and flow properties of granular systems

Tailoring the Wettability of Polypropylene Surfaces with Halloysite Nanotubes

Molecular Investigations on the Adsorption and Flow Behavior of Hydroxyl-Terminated Polybutadiene (HTPB) Binders on Cu Surfaces: the Effects of Surface Nanostructure and Perfluorosilylation

Preparation of high impact polypropylene with high ethylene content by gas phase process