Abstract:In situ thermal desorption (ISTD) has widely been applied for remediating petroleum hydrocarbons (PHs)contaminated sites. Towards decarbonization of the energy-intensive ISTD of PH-contaminated sites, the knowledge on the soil thermal conductivity, in the presence of both water and PHs, is important for modeling and analysis of the underground heat and mass transport. In this work, an experimental study of the temperature- dependent thermal conductivity of PH-contaminated soil (using diesel as an example of light PHs) based on the transient line heat source method was performed, at low temperatures down to-25 degrees C with applications to PH- contaminated sites at cold regions, such as oil refineries in northern China, northern USA and Canada, etc. Contaminated soil samples were taken from a remediation demonstration site in Gansu, China. It was found that the soil thermal conductivity increases with the rise in initial water content. As the temperature decreases to around-25 degrees C, the soil thermal conductivity sharply increases due to the crystallization of water. However, as the water-ice phase change diminishes, the increasing trend in thermal conductivity gradually decelerates and ultimately reaches a stable state. Since diesel does not undergo a phase change process at the low temperatures studied, varying diesel content in soil only changes the magnitude of the soil thermal conductivity, not its trend with temperature. Based on the series-parallel hybrid framework, an effective thermal conductivity model was established that takes initial water content, diesel concentration, unfrozen water content, and frost heave into account. The results show that the predicted thermal conductivity via the model aligns well with the measured data.

Effect of carrier gas flow rate and heating rate on thermal desorption of polychlorinated biphenyls in contaminated soil

Effect of Carrier Gas Flow Rate in Thermal Desorption Process of Pcbs Contaminated Soil

Effect of temperature and particle size on the thermal desorption of PCBs from contaminated soil

Effect of oxygen content on the thermal desorption of polychlorinated biphenyl-contaminated soil

Thermal Desorption for Remediating PCB-contaminated Soil

Dispersive liquid-liquid microextraction combined with gas chromatography-electron capture detection for the determination of polychlorinated biphenyls in soils.

Effects of Thermal Desorption Temperature Up to 500°C on the Thermophysical Properties and Fertility of Soil in Organic-Contaminated Sites

Removal of Pollutants from High Polychlorinated Biphenyl Level Contaminated Soil at Different Thermal Treated Time

Combined mechanochemical and thermal treatment of PCBs contaminated soil

Thermal desorption of PCBs from contaminated soil with copper dichloride

Mechanochemical Remediation of 3,4,3′,4′-Tetrachlorobiphenyl (PCB77) Contaminated Soil by Ball Milling and a Novel Technology Combining Ball Milling with Dielectric Barrier Discharge

Thermal desorption of PCB-contaminated soil with sodium hydroxide

Disturbance and Restoration of Soil Microbial Communities after In-Situ Thermal Desorption in a Chlorinated Hydrocarbon Contaminated Site.

Study on the Effective Thermal Conductivity of Typical Light Petroleum Hydrocarbons-Contaminated Soil at Low Temperatures

Investigation on drying and emission performances of PCBs contaminated soil during thermal desorption pretreatment process

Remediation of PCB-contaminated Soil Using a Combination of Mechanochemical Method and Thermal Desorption

PCDD/F formation during thermal desorption of chlorobenzene contaminated soil

PCDD/F Formation During Thermal Desorption of P,p′-Ddt Contaminated Soil

Thermal Desorption of PCBs from Contaminated Soil Using Nano Zerovalent Iron.

Effects of Rameb And/Or Mechanical Mixing on the Bioavailability and Biodegradation of Pcbs in Soil/Slurry

Analysis of thermal processing applied to contaminated soil for organic pollutants removal