Abstract:Silver was immobilized onto the surface of a chitosan membrane to examine the anti-biofouling performance of the membrane surface. The chitosan base membrane (denoted as CS) was first immobilized with ionic silver (denoted as CS_Ag+) and then the CS_Ag+ membrane surface was chemically treated to obtain the membrane surface with reduced or metallic silver (denoted as CS_Ag-0). The oxidation states of the immobilized silver on CS_Ag+ and CS_Ag-0 and the interaction between silver and CS were investigated with X-ray photoelectron spectroscopy (XPS). The stability of the immobilized silver on the two types of membrane surfaces was evaluated through a leaching test. It was found that silver was effectively immobilized onto CS through surface complexation and the immobilized silver on CS_Ag-0 was at a reduced or lower oxidation state and was more stable than that on CS_Ag+. Anti-bacterial and anti-biofouling experiments for CS. CS_Ag+ and CS_Ag-0 were conducted with two types of typical bacteria, i.e., E. coli and Pseudomonas sp. From the disk diffusion tests (for 24h), it was found that, as compared to CS, both CS_Ag+ and CS_Ag-0 showed significantly improved anti-bacterial performance, even though the CS_Ag+ membrane surface seemed to exhibit slightly stronger anti-bacterial effect than the CS_Ag-0 membrane surface. In the longer time immersed experiments in bacteria suspensions for anti-biofouling performance (up to 10 d), both CS_Ag+ and CS_Ag-0 showed much less biofouling than CS and they behaved almost equally good in their anti-biofouling behavior initially (24 h), but the CS_Ag-0 membrane surface gradually exhibited more stable and eventually better anti-biofouling performance than the CS_Ag+ membrane surface afterwards. The results in this study demonstrated that the immobilization of silver onto membrane surfaces can be an effective method to improve a membrane's anti-biofouling property. The study was also the first of its kind that evaluated the relative anti-biofouling performance by immobilized silver in ionic and reduced states on a membrane surface. (C) 2010 Elsevier B.V. All rights reserved.

Effects of Stabilizers and Antifoggants on Imaging Process of Silver Chloride

Crystallization of Silver Stearate from Sodium Stearate Dispersions.

Studies on Mechanisms of Stabilizers and Antifoggants on AgCl Microcrystal by the Method of Chemical Microscopy

Tackling the Stability Issues of Silver Nanowire Transparent Conductive Films through FeCl3 Dilute Solution Treatment

Effects of Diethanolamine on the Evolution of Silver/titanium Dioxide Sol–gel Process

Sabattier Effect in Internally Sensitive Emulsions

Iron In Photographic Gelatin .2. The Influence Of Fe2+ Lens In Gelatin Medium On Chemical Sensitization Of Silver Halide

Membrane surfaces immobilized with ionic or reduced silver and their anti-biofouling performances

Study of Fish Gelatin as a Carrier of Silver Halide Nanoparticles

Improvement in Photosensitivity of Ultra-Fine Silver Halide Emulsion Microcrystals

Effects of Heat-Treatment Temperature on Preparation of the Sol-Gel-Derived Ag/TiO2 Films

Study on Crystallization Behavior of Novel Silver Chloride Based Chalcogenide Glasses

STUDY OF CUPRIC IONS (CU-2+)-DOPING EFFECT IN CUBIC SILVER-CHLORIDE EMULSION

Characterization of AgBr/I nanoparticles prepared in fish gelatin

COMPOSITION AND CHEMICAL-STATE OF IMAGES INTENSIFIED BY COPPER PHYSICAL DEVELOPMENT

Decrease in the Photosensitivity of an Emulsion by Iron (ii) in Gelatin

Styryl Cyanine Dyes: Aggregate Behaviour, Electrochemical Properties and Photographic Performance

The Formation, Stabilization and Physicochemical Properties of Silver Clusters in Aqueous Solution--Progress in Pulse Radiolysis Study

[Effects of Chemical Sensitization on Photoelectron Time-Resolved Spectrum].

Photoelectron Behaviors of Silver Halide Microcrystals

Effect of Concentration of Aluminum Salts on Stability of Aluminosilicate Sand Stabilization Material