Abstract:The effect of different type of heteropolyacid/Zr-MCM-41 catalysts on the catalytic amination of glycerol with dimethylamine to produce Dimethylamino-3-propanal was researched. Under the premise of their respective optimum loading amount, the specific surface area, pore volume and pore size of the H6P2W18O62/Zr-MCM-41(Cat-2) were higher than those of the H3PW12O40/Zr-MCM-41(Cat-1). Cat-1 exhibited more total acidity than that of Cat-2, which resulted in the higher glycerol conversion of Cat-1 at the beginning of the reaction, but the coke deposited on Cat-1 was more than that of Cat-2. The amount of Bronsted acid sites and ratio of B/(B + L) on Cat-2 were higher than that of Cat-1. Therefore, the catalytic stability, selectivity and yield of Dimethylamino-3-propanal of Cat-2 were higher than those of Cat-1, which proved that the Bronsted acid sites are good for the catalytic amination of glycerol with dimethylamine to produce Dimethylamino-3-propanal. The leaching ratio of Cat-2 is slightly more than that of Cat-1, because H6P2W18O62 is more hydrophilic than H3PW12O40. However, the stability of Cat-2 is higher than that of Cat-1, therefore, the main reason for deactivation of catalyst is the formation of carbon deposit during this reaction. And the reaction pathway of catalytic amination of glycerol with dimethylamine was proposed. Furthermore, the reaction temperature, GHSV and the molar ratio of dimethylamine/glycerol were optimized on Cat-2 catalyst. Under the optimum reaction conditions: 300 degrees C, H6P2W18O62 loading of 20 wt%, GHSV of 3 h(-1), glycerol aqueous concentration of 10 wt%, dimethylamine aqueous concentration of 30 wt%, molar ratio of dimethylamine/glycerol of 2.5, the glycerol conversion, selectivity and yield of Dimethylamino-3-propanal were 95.6%, 80.8% and 77.2%, respectively.

Research on synthesis of polyether amine via catalytic amination under atmospheric pressure

Amination Based on the System of Ammonium Formate-Pd/c

Synthesis of N, N-dimethyl-n-butylamine with Tubular Reactor

Kinetics and Simulation of the Imidization of Poly(styrene‐co‐maleic Anhydride) with Amines

The synthesis of N -ethyl- n -butylamine by amines disproportionation

Catalytic Synthesis of N,N,N',N'-tetramethylethylenediamine in Fixed-Bed Reactor

Synthesis of Cyclopentane with Cyclopentanone by the Method of Catalytic Aminolysis

Synthesis of an Amine Terminated Polyether: Effects of the Activation Conditions on a Raney Nickel Catalyst

Preparation of Trifunctional Amine Terminated Polyether

Methylamine Synthesis over Solid Acid Catalysts: Reaction Kinetic Measurements

Effect of Phosphorus Precursor, Reduction Temperature, and Support on the Catalytic Properties of Nickel Phosphide Catalysts in Continuous-Flow Reductive Amination of Ethyl Levulinate

Rationally Engineering a CuO/Pd@SiO2 Core-Shell Catalyst with Isolated Bifunctional Pd and Cu Active Sites for N-Butylamine Controllable Decomposition

Atmospheric Pressure Synthesis Of Nanosized Zsm-5 With Enhanced Catalytic Performance For Methanol To Aromatics Reaction

Catalytic Amination of Glycerol with Dimethylamine over Different Type Ofheteropolyacid/zr-Mcm-41 Catalysts

A practical and benign synthesis of amines through Pd@mpg-C 3 N 4 catalyzed reduction of nitriles

Palladium Catalyzed Aerobic Oxidative Amination of Alkenes

N ‐Monomethylation of Amines with Methanol by Syndiotactic Poly(aminostyrene)‐supported Palladium Nanoparticle Catalyst

Heterogeneous Catalytic Aerobic Oxidation of Primary Amines to Amides Using Unsupported Nanoporous Palladium Catalyst

Synthesis of Diphenylamine by Condensation of Aniline Catalyzed by Microporous-Mesoporous Composite Solid Acid Nanoreactor

Efficient Synthesis of Polyoxymethylene Dimethyl Ethers on Al-SBA-15 Catalysts with Different Si/Al Ratios and Pore Sizes

Efficient and Scalable Pd-catalyzed Double Aminocarbonylations under Atmospheric Pressure at Low Catalyst Loadings