Abstract:We study the specific catalytic effect of the catalyst on the combustion process of pulverized coal of increasing the proportion of semicoke in the mixture of semicoke and bituminous coal, and reducing the cost of blast-furnace coal injection. A combination of thermogravimetric and kinetic analyses were used to study the catalytic effect of Fe2O3 on semicoke and bituminous coal, and to improve the amount of semicoke in the mixed coal powder of bituminous coal and semicoke. Experimental results showed that Fe2O3 had a catalytic effect on both semicoke and bituminous coal, but there were differences in the catalytic stages of the same catalyst for different pulverized coal types. The addition of 2 wt % Fe2O3 to semicoke and bituminous coal each led to the ignition temperature and maximal burning rate temperature of the semicoke decreasing, indicating that the catalyst promoted the precipitation of a volatile fraction from the semicoke. The maximal burning rate temperature and burnout temperature of the bituminous coal decreased, and maximal weight loss rate increased, indicating that the catalyst promoted the combustion of the fixed carbon of bituminous coal. The optimal proportioning amount of semicoke in the mixed coal powder without the addition of a catalyst was 25%. After adding 2 wt % Fe2O3, the proportional amount of semicoke increased by 10%. The addition of the catalyst resulted in even lower activation energy for the same conversion rate. When the conversion rate was in the ranges of 0.1–0.2 and 0.5–0.7, the activation energy decreased by 22% and 26%, respectively, compared with that without a catalyst. Fe2O3 promoted the combustion of bituminous coal and semicoke. This enhanced the combustion performance of the pulverized coal mix and increased the proportion of semicoke in the mix, which has certain guiding significance in reducing the cost of blast-furnace iron making.

Catalysis Colequefaction of Coal and Biomass

Comparison of Effect of Ferric Sulfide Catalyst and Nickel Sulfide on Coliquefaction of Coal and Biomass

Coliquefaction of coal and sawdust

A Comparison of FeS, FeS + S and solid superacid catalytic properties for coal hydro-liquefaction

Catalytic Influence of Iron Oxide (fe2o3) on Coal Pyrolysis and Char Combustion at Various Temperatures

Synthesis, characterization and evaluation of Cu/MgAlFe as novel transfer catalyst for SOx removal

Coliquefaction Of Coal And Biomass Waste

A CoFe Bimetallic Catalyst for the Direct Conversion of Syngas to Olefins

EFFECT OF IRON CATALYST ON PRODUCT COMPOSITION AND NATURE FOR COAL/OIL CO-PROCESSING

Highly Dispersed FeAg-MCM41 Catalyst for Medium-Temperature Hydrogen Sulfide Oxidation in Coke Oven Gas.

Synthesis and Catalysis of Oleic Acid-Coated Fe3O4 Nanocrystals for Direct Coal Liquefaction

Direct Liquefaction of Coal Using Ferric-Sulfide-Based, Mixed-Metal Catalysts Containing Mg or Mo

Simultaneous Recovery of Carbon and Sulfur Resources from Reduction of CO2 with H2S Using Catalysts

Preparation and performance of Fe nanoparticle desulfurizer for hot coal gas desulfurization

Effect of Co-Feeding Carbon Dioxide on Fischer–Tropsch Synthesis over an Iron–manganese Catalyst in a Spinning Basket Reactor

EFFECT OF COAL-SWELLING AND SYNCHRONOUSLY SUPPORTED CATALYSTS ON COPROCESSING OF BITUMINOUS COAL AND HEAVY OILS

Direct Liquefaction Performance of Sub-Bituminous Coal from Hefeng by Solid Super Acids and Pyrolysis Kinetic Analysis of the Corresponding Residue

Effects of Iron Catalyst and Atmosphere on Sulfur Transformation During Pressurized Low-Temperature Pyrolysis of Baishihu Coal

Enhanced Combustion of Bituminous Coal and Semicoke Mixture by Ferric Oxide with Thermographic and Kinetic Analyses

Influence of CoAl2O4 spinel and Co-phyllosilicate structures derived from Co/sepiolite catalysts on steam reforming of bio-oil for hydrogen production

Impact of H2/CO Ratios on Phase and Performance of Mn-modified Fe-based Fischer Tropsch Synthesis Catalyst