Abstract:Graphite, a nonmetallic mineral composed of carbon, relies on carbon stable isotopes for tracing the material source, growth enrichment and mineralization processes. In this study, we leverage laser ablation multi-collector inductively coupled plasma mass spectrometry (LA-MC-ICP-MS) to establish an in situ analysis method with medium resolution (∼5000) for carbon stable isotopes. Two potential in-house graphite reference materials from the Lutang deposit in Hunan Province and the Changshouyuan deposit in Jiangxi Province, China, were prepared using the tableting method. Twenty measurements on each of the two samples indicate relatively homogeneous carbon stable isotope composition with a RSD of uncorrected 13 C/ 12 C ratios at approximately 0.030% (LTSM: 0.032%, CSY: 0.027%). Additionally, the laser repetition rate was gradient changed (2–20 Hz) to investigate the influence of concentration effect caused by changes in the signal-to-noise ratio (SNR) on the measurement results. When the SNR > 1.23, 13 C/ 12 C-2SE no longer drops significantly. Constructing working curves of the SNR and isotope ratio can correct the concentration effect. No matrix effect was observed between the two graphite samples. A slight matrix effect was observed between graphite and dolomite and a strong matrix effect exists between graphite and calcite. The δ 13 C analysis of graphite from six different mining areas was conducted, and the LA-MC-ICP-MS results, when corrected using the standard-sample-bracketing (SSB) method and LTSM samples, exhibit reasonable agreement with the δ 13 C values reported in previous and current studies using IRMS. This study demonstrates the feasibility of in situ measurement of carbon stable isotopes in graphite using LA-MC-ICP-MS, characterized by high efficiency, cost-effectiveness and high spatial resolution. The two types of graphite are suitable to be used as reference materials for in situ measurement of carbon stable isotopes in graphite using LA-MC-ICP-MS.

Determination of graphite content in high-graphitic cathode carbon block

INFLUENCE OF GRAPHITE CONTENT ON PENETRATION INTO CATHODE BLOCKS

Carbon Blocks from Natural Flake Graphite and Mesophase Pitch: Fabrication Processing, Microstructre, Mechanical Property, and Electrical Perfromance

In situ carbon stable isotope measurement for graphite using LA-MC-ICP-MS

Measurement of Carbon Amount in Carbon-Coated Graphite by Thermal Analysis

Graphite Equivalent Evaluation of Anthracite-Associated Graphite by Raman Spectroscopy

Itemized determination of As, Sb, Bi, Se, and Ge in graphite sample by HG-AFS with high-temperature microwave digestion

A New Method to Fabricate Large Amount of Single-Walled Carbon Nanotubes

Determination of concentrations of trace elements in nuclear grade graphite by charged particle activation analysis

Optimization of Lithium Metaborate Fusion and Post-ultrasonic Extraction for Multi-element Determination in Graphite by ICP-AES

Binding Natural Graphite with Mesophase Pitch: A Promising Route to Future Carbon Blocks

Determination of Nickel, Cobalt and Manganese in cathode material of Lithium ion Batteries

Determination of Total Sulfur in Graphene with Organic Elemental Analyzer

Determination of micro content cabon element in catalytic cracking catalyst by coulometry

Determination of impurity distribution in IG-11/110 nuclear graphite using TOF-SIMS

Effect of kneading and carbonization temperature on the structure of the carbon block for thermally conductive bulk graphites

Graphite Blocks with Preferred Orientation and High Thermal Conductivity

Short-Range Promotion and Long-Range Inhibition Mechanism of Sulfur Release in High-Sulfur Petroleum Coke for Fast-Charging Graphite Anodes

Testing and Modeling the Mechanical Properties of the Granular Materials of Graphite Anode

Investigation of Lithium Ion Diffusion of Graphite Anode by the Galvanostatic Intermittent Titration Technique

Experimental Study of Flake Graphite Large-Area Explosion Electron Emission Cathode Performance Based on Particle Size Discrepancy