Abstract:Undrained cyclic loading patterns and consolidation states can significantly affect the deformation features of medium-dense saturated fine-grained sand. A series of undrained cyclic loading tests with different consolidation states, i.e., various mean effective consolidation stresses (p0), principal stress direction angles (α0), ratios (R0) of major and minor principal stresses, and relative magnitudes of intermediate principal stress (b0), were performed on saturated micaceous fine sand specimens with a relative density of 50% corresponding to a wide strain range in the order of 10−5 to 10−2. The patterns of cyclic axial, torsional, and axial–torsional combined loadings were applied in a hollow cylinder apparatus. The small-strain shear modulus G0, the reference shear strain γr, curves for shear modulus reduction G/G0, the damping ratio λ and Poisson's ratio υ with increasing strain were determined. The results of the cyclic axial–torsional combined tests showed a close relationship between G0, γr, and υ as well as the consolidation state parameters p0, R0, α0, and b0. The G0 and γr increased nearly linearly with increasing p0 and with decreasing α0 or b0. The υ is strain dependent and increases as the p0 decreases. Tests indicated that the reduction of G with increasing shear strain γ became more pronounced as p0 increased. The relationship for the G/G0 versus γ/γr was approximately independent of the cyclic loading patterns and the various values of parameters p0, R0, α0, and b0. A slight difference is noted between the damping ratios λt and λz, corresponding to vertical and torsional deformations. An empirical model was proposed for the dependence of the increase in damping ratio characteristics on the deviatoric strain.

Experimental study on influences of fines content and consolidation stress on shear modulus and damping ratio of saturated sand

Cyclic Flow Behavior of Anisotropically Consolidated Sand with a Small Amount of Fines

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Experimental study on stiffness change of saturated soft clay with different degrees of consolidation under cyclic loading

Influences of fines content on cyclic resistance ratio of fines-sand-gravel mixtures

Experiment of initial relative density effects on sand strength

Laboratory Study on Self-Weight Sedimentation and Consolidation Behaviors of Hydraulic-Dredged Mud

Experiment of dynamic shear modulus and damping of Nanjing fine sand

Experimental Study on Dynamic Characteristics of Saturated Remolded Soft Clay with Sand Particles

Experimental Study on Dynamic Elastic Modulus and Damping Ratio of Xiaoshan Saturated Soft Clay Considering Initial Deviator Stress

RESEARCH OF DYNAMIC PROPERTIES CHANGES AND MICROSCOPIC MECHANISM OF AGEING SAND

Shear Modulus and Damping Ratio of Sand–Gravel Mixtures Over a Wide Strain Range

Experimental Study of Cyclic Shear Stiffness and Damping Ratio of Carbonate Sand-Steel Interface

The Influence of Undrained Cyclic Loading Patterns and Consolidation States on the Deformation Features of Saturated Fine Sand over a Wide Strain Range

Effects of consolidation conditions on the dynamic shear modulus of saturated coral sand over a wide strain range

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

A New Method For Evaluating Small-Strain Shear Modulus Of Sandy Soils Based On Binary Medium Model

Reduction of Dynamic Shear Modulus of Saturated Marine Sandy Silt under Complex Stress Conditions

Laboratory Experimental Research on Dynamic Shear Modulus of Saturated Soil Subjected to Dynamic Loading

Undrained shear behavior of silty sand with a constant state parameter considering initial stress anisotropy effect