Performance optimization of vortex hydro-brake and experimental study under different working conditions

Lei Zhang,Yanming Wu,Wentao Cheng,Tao Li,Chao Li,Guangfei Ma,Yu Zheng
DOI: https://doi.org/10.3969/j.issn.1002-8471.2017.06.026
2017-01-01
Abstract:Vortex hydro-brake is a flow control device that can be used in the urban rainwater drainage system to regulate peak flows.Experiments were carried out after the installation of the prototype of the hydro-brake in a physical model of rainwater drainage system with a D200 pipe and the results showed as follows:① The curve recorded in the experiment was basically consistent with the trend calculated by simulation.At low water level,the hydro-brake wouldn't change the discharge characteristics of the drainage system,while at high water level it would produce vortex via self-excitation,thus achieving a stagnant effect and saving some water storage space.② The installation of baffle and change of the baffle angle could effectively improve the stagnation performance,and the throttling effect was best when the baffle angle α was 15 degrees.③ The ‘S’part of the curve represented the transition of vortex from appearance to stabilization,and the device's (discharge capacity was equivalent to an orifice's when the vortex was stable.Until the water level dropped to the position where the inside and outside air pressures of the device were equal,the discharge capacity of hydro-brake returned to the initial state.④ The position of the ‘S’ part of the characteristic curve rose with the increase of the back pressure.
What problem does this paper attempt to address?