Abstract:Urban flooding as a result of inadequate drainage capacity, failure of flood defenses, etc. is usually featured with highly transient hydrodynamics. Reliable and efficient prediction and forecasting of these urban flash floods is still a great technical challenge. Meanwhile, in urban environments, the flooding hydrodynamics and process may be influenced by flow regulation and flood protection hydraulic infrastructure systems, such as sluice gates, which should be effectively taken into account in an urban flood model. However, direct simulation of hydraulic structures is not a current practice in 2D urban flood modeling. This work aims to develop a robust numerical approach to directly simulate the effects of gate structures in a 2D high-resolution urban flood model. A new modeling component is developed and fully coupled to a finite volume Godunov-type shock-capturing shallow water model, to directly simulate the highly transient flood waves through hydraulic structures. Different coupling approaches, i.e., flux term coupling and source term coupling, are implemented and compared. A numerical experiment conducted for an analytical dam-break test indicates that the flux term coupling approach may lead to more accurate results, with the calculated RMSE against water level 28%–38% less than that produced by the source term coupling approach. The flux term coupling approach is therefore adopted to improve the current urban flood model, and it is further tested by reproducing the laboratory experiments of flood routing in a flume with partially open sluice gates, conducted in the hydraulic laboratory at the Zhejiang Institute of Hydraulics and Estuary, China. The numerical results are compared favorably with experimental measurements, with a maximum RMSE of 0.0851 for all the individual tests. The satisfactory results demonstrate that the flood model implemented with the flux coupling approach is able to accurately simulate the flow through hydraulic structures, with enhanced predictive capability for urban flood modeling.

Numerical Modeling of the Hydrodynamic Performance of Slanted Axial-Flow Urban Drainage Pumps at Shut-Off Condition

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Simulation of Inlet and Outlet Passages for Axial Flow Pump in Drainage Pump Station

Three-dimensional Numerical Analysis on a New Design of Hydraulic Structure for Water Treatment

Effect of Suction and Discharge Conditions on the Unsteady Flow Phenomena of Axial-Flow Reactor Coolant Pump

Investigating the Hydraulic Performance of Slanted Axial Flow Pumps Using an Enstrophy Dissipation-Based Hybrid Optimization Approach

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct

Hydraulic Performance of a Large Slanted Axial‐flow Pump

Hydraulic Performance Optimization of a Submersible Drainage Pump

Analysis of the Internal Flow Behavior on S-shaped Region of a Francis Pump Turbine on Turbine Mode

Simulation of Hydraulic Structures in 2D High-Resolution Urban Flood Modeling

Performance improvement of 1000 kw axial-flow submersible pump

Fluid-Structure Coupling Analysis of a Pump-turbine Unit During the Pump Shutdown Transient Process

Numerical Investigation on the “S” Characteristics of a Reduced Pump Turbine Model

Performance analysis and experimental verification of hydraulic driven axial flow pumps

The Influence of Hydraulic Characteristics on Structural Performance in a Pump-Turbine under No-Load Conditions

Numerical investigation of stalled flow in pump turbine under off-design condition

Simulations of Near-Zero Head Flow in a Large Slanted Axial Pumping Station