Abstract:Ultra-high-rise buildings require high concrete bearing capacity. Ordinary concrete often fails to meet the project requirements. Admixture of admixtures in concrete is a means of solution. Currently, studies on the incorporation of basalt fiber (BF) and fly ash (FA) in concrete are relatively mature. However, research on incorporating nano-Titanium Carbide (nano-TiC) in concrete is still relatively scarce, which has a lot of room for development. To further improve the mechanical properties of concrete, BF, and FA synergized with nano-TiC were incorporated into concrete to produce TBF concrete in this study. And Response Surface Methodology (RSM) was used to optimize the mechanical properties of concrete. The collapse and compressive deformation damage characteristics of concrete were analyzed. The microstructure of the cement matrix was analyzed by the SEM (Scanning Electron Microscope). An optimization model of the TBF concrete craving function was developed. Optimized ratios with compressive, split tensile, and flexural strengths as response objectives were obtained, and the accuracy of the optimized ratios was investigated using the same experimental conditions. The results of the study showed that FA increased the collapse of concrete, while nano-TiC and BF decreased the collapse of concrete. Under uniaxial compression, nano-TiC, FA, and BF together incorporated into concrete can improve its compressive damage state. Moderate amounts of nano-TiC, BF, and FA could improve the mechanical properties of concrete. Their optimal mixing ratio admixtures were 0.88%, 0.24%, and 5.49%, respectively. And the measured values under the same conditions were compared with the predicted values. The maximum difference in compressive strength was 6.09%. The maximum difference in split tensile strength was 7.14%. The maximum difference in flexural strength was 8.45%. This indicated that the accuracy of the RSM optimization model was good. A moderate amount of nano-TiC, FA, and BF could improve the densification of concrete.

Experimental Research on the Using of FJ1-activator in High Strength Concrete with High Content of Fly Ash

Study on the Effect of Fly Ash and Polycarboxylic Acid Water Reducer on the Properties of Recycled Concrete

Experimental study on the activators of fly ash

Research on Improving Cementitious Material Properties by Adding FineFly Ash

Study on Mechanics Property Experiments of High Fly Ash Content Concrete

Influence of Mineral Admixture on Early-Age Concrete Cracking

Influence of Alkaline Activator on the Strength of Fly Ash-Cement Gel Sand Material

Strength and Microstructural Characteristics of Activated Fly Ash–Cement Paste

Strength characteristics of self-compacting concrete with alkali-activated fly ash

Effects of compound activators on the early mechanical properties of cement mortar incorporating large volume of fly ash

Experimental Study on the Cracking Resistance at Early Ages of High Performance Concrete Added with Lithium Slag and Fly Ash

The role of fly ash microsphere in the microstructure and macroscopic properties of high-strength concrete

Research on the High Strength Pumping Concretes with Grade-Ⅱ fly Ash and Slag Micro Powder

Experimental study on the mechanical behavior of concrete incorporating fly ash and marble powder waste

Hydration and Strength Evolution of Ternary-Blend High-Volume Fly Ash Concretes

The Differences among the Roles of Ground Fly Ash in the Paste, Mortar and Concrete

Experimental study on the utilization of Fly ash solid waste in tunnel shotcrete materials

Compressive, flexural and splitting strength of fly ash and silica fume concrete

Research on mechanical properties of concrete by nano-TiC-BF-fly ash

Microstructure and Strength Development of Quaternary Blend High-Volume Fly Ash Concrete

Experimental Application of Mineral Admixtures in Lightweight Concrete with High Strength and Workability