Simultaneous Degradation of p-Nitrophenol and Recovery of Copper from Wastewater in Electrochemical Reactor Under High Salinity
Xin Tan,Zhijie Zheng,Bo Peng,Xiaogang Wu,Xiangyang Huang,Xiaofei Chen
DOI: https://doi.org/10.1166/sam.2021.4120
2021-12-01
Science of Advanced Materials
Abstract:Ti/RuO 2 –IrO 2 electrode was used in this study as an anode, while titanium plate (Ti) was used as a cathode for electrochemical oxidation process, to explore the influences of related parameters on degradation of p-nitrophenol (PNP) and removal of Cu 2+ from mixed simulated wastewater. Using a single chamber reactor, we tested the influence of various factors on the PNP degradation and Cu 2+ elimination. The factors that were tested are as follow; the type of electrolyte, density of the current, various values of pH and different concentrations of Cu 2+ . Furthermore, a dual-chamber diaphragm reactor compartmentalized by cationic membrane was utilized to explore the removal mechanism of PNP and Cu 2+ . Results showed that, treatment of PNP-Cu 2+ simulated wastewater, with NaCl as electrolyte, had a better effect compared with Na 2 SO 4 , which had characteristics such as shorter reaction time and higher degradation efficiency for PNP. Removal of Cu 2+ had no obvious advantage over Na 2 SO 4 . The degradation of PNP and removal of Cu 2+ were improved with increased current density when the rang was increased from 10 to 40 mA/cm 2 . Cu 2+ concentration when increased initially promoted the degradation of PNP. At the same time, Cu 2+ acted as electron acceptor at the cathode that slowed down the consumption of H + through reduced combination of H + with electrons. The degradation rate of PNP decreased with increased initial pH, but the Cu 2+ was opposite. In this experiment, the degradation of PNP was positively correlated with indirect oxidation of active chlorine, and the Cu 2+ was removed by cathodic electrodeposition.
materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology