Simultaneous Removal of Cr(Ⅵ) and Cr(Ⅲ) by Titanate Nanosheets Through Photocatalysis Combined with Adsorption

Ting WANG,Wen LIU,Xuezhao LI,Xiaolin JIAO
DOI: https://doi.org/10.7524/j.issn.0254-6108.2015.10.2015032302
IF: 4.236
2015-01-01
Environmental Chemistry
Abstract:Titanate nanosheets ( TNS) were prepared using hydrothermal method via anatase TiO2 as raw material. The adsorption processes of Cr(Ⅵ) and Cr(Ⅲ) onto TNS were thoroughly studied, and simultaneous removal of Cr (Ⅵ) and Cr (Ⅲ) by synergetic photocatalysis and adsorption at various pHs was investigated. TEM and XRD analysis indicated that the as?prepared TNS exhibited multiple phases of anatase TiO2 and titanate, which were important for their photocatalysis and adsorption performance. Batch adsorption experiments depicted that pH significantly affected Cr(Ⅵ) and Cr(Ⅲ) adsorption onto TNS. The adsorption capacity of Cr(Ⅲ) was enhanced with increasing pH, while that of Cr(Ⅵ) was decreased. Both Cr(Ⅵ) and Cr(Ⅲ) were adsorbed rapidly by TNS, with the adsorption kinetics fitted well with the pseudo?second model (R2>0.99). In addition, the Langmuir model can describe well the adsorption isotherms of both Cr (Ⅵ) and Cr (Ⅲ) ( R2>0.99), and the saturated adsorption capacity of Cr(Ⅲ) (13.19 mg·g-1) was much larger than that of Cr(Ⅵ) (0.63 mg·g-1). Therefore, adsorption alone is not an effective method for removal of Cr(Ⅵ) and photocatalysis is needed. Synergetic experiments of photocatalysis and adsorption suggested the apparent rate constant of Cr(Ⅵ) photocatalysis decreased dramatically with increase pH, while the adsorption of Cr(Ⅲ) was obviously facilitated. Taken together, the optimal pH for the synergy of photocatalysis and adsorption was pH 5, at which the removal efficiency of Cr(Ⅵ) and total Cr reached as high as 97. 6%, and Cr (Ⅲ) was not detected in the solution. This study has provided a promising method for simultaneous removal of Cr(Ⅵ) and Cr(Ⅲ) from the wastewater.
What problem does this paper attempt to address?