Preparation of MnO2 ceramsite and its catalytic activity for ozone oxidation

Shuhan Wen,Qinping Yao,Weiqi Li,Ke Xu,Hongqiang Ren
DOI: https://doi.org/10.3969/j.issn.1006-1878.2018.02.006
2018-01-01
Abstract:MnO2 ceramsite catalyst was prepared using attapulgite as carrier and MnO2 as active component. The preparation conditions were optimized by response surface methodology using oxalic acid as simulated contaminant. The experimental results showed that the significant factors affecting oxalic acid removal rate were in the order of MnO2 amount,hydrochloric acid solution mass fraction,calcination time and calcination temperature. The optimum conditions for catalyst preparation were as follows:MnO2 amount 200 mg/g,hydrochloric acid solution mass fraction 20%,calcination time 2 h and calcination temperature 400 ℃. Under the conditions of initial oxalic acid mass concentration 150 mg/L,solution pH 3.11,ozone amount 8.10 mg/min,ozone-oxygen aeration rate 400 mL/min and reaction time 30 min,the removal rate of oxalic acid was 66.99%. The catalyst had good activity stability with low Mn2+ dissolution. Moreover,the catalyst had a large specific surface area and the types of MnO2 supported on the catalyst were α-MnO2 and β-MnO2.
What problem does this paper attempt to address?