Effects of bentonite and its modified version on the stabilization of heavy metal contents in the electroplating sludge

Xin CONG,Tong ZHU,Jian-fei YAN,Yue ZHANG

DOI: https://doi.org/10.13637/j.issn.1009-6094.2017.03.064

2017-01-01

Abstract:The paper is entitled to study the effects of the bentonite and its modified version on the stabilization of the heavy metal contents in the electroplating sludge by using the sludge samples we have collected from an electroplating factory with noticeable concentration rate of heavy metals in.For the study purpose,we have adopted a method known as the toxicity characteristics leaching procedure (TCLP) in hoping to stabilize the effects of the bentonite and its modified version on the heavy metalcontents in the said sludge.The stabilization experiment results we have obtained prove that the leaching toxicity rates of the heavy metals Cr,Cd,Zn and Pb in the sludge account for 154 mg/L,13.5 mg/L,658 mg/L and 76 mg/L respectively,on the condition with no bentonite and modified bentonite added,thus,suggesting that the effects of the heavy metals in the leaching solution can be lowest if it is possible to satisfy the dosage range limit and the oscillation time.For example,on the condition that the oscillation time we have chosen is 12 h and the addition amounts of bentonite and modified bentonite are equal to 0.2 g/g and 0.3 g/g.Such stabilizing effects of the heavy metals in the sludge can be made optimistic when the heavy metal contents to be treated with bentonite and modified bentonite are mainly made of organic contents in the residual state.In such a situation,the content rate of the unstable state would be lower than that of the sludge without being treated by the bentonite.Moreover,the heavy metal contents in the sludge treated by the modified bentonite may tend to be less active than that in sludge treated by the unmodified one.However,the results of the infrared spectrum analysis demonstrate that the basic structure of the modified bentonite tends to remain unchanged.What is more,the electronic microscopy scanning also proves that the modified bentonite tends to assume more sheet and layered structures on the surface.At the same time,the adsorption power of the modified bentonite can slightly be made higher than that of the unmodified.Hence,it can be inferred that the stabilizing mechanism of heavy metals in the sludge by bentonite and modified bentonite can be mainly displayed through adsorption and ion exchange based on the above analysis,which suggests that the stabilization effect gained by with the modified bentonite turns to be better than that with the unmodified one.