Abstract:When a sluice gate is arranged in parallel with pumping station units, biased flow occurs in the forebay when the units are operating. The transverse flow velocity in front of the channel inlet is relatively high, and, in severe cases, it may lead to the formation of suction vortices, impacting the stable operation of pump units. Taking the Liushan Pumping Station project of the Eastern Route of the South-to-North Water Diversion Project as a case study, this paper investigates the effect of the partition wall length on the inlet flow regime of pumping station units arranged in parallel with the sluice gate to reduce the transverse flow velocity in front of the channel inlet. Using numerical simulations, the inlet flow regimes for different partition wall lengths were compared. Moreover, the flow field distributions in the forebay under different operating conditions were analyzed alongside the transverse flow velocity in front of the channel inlet and the uniformity of flow velocity distribution in the section behind the channel inlet. Hydraulic model tests were then conducted to validate the simulation results. The results indicate that in the original design, there existed a vortex zone in the forebay in front of the inlet of the channel where the transverse flow was relatively high. However, the introduction of partition walls significantly reduced the transverse flow velocity in front of the inlet of the channel in the forebay. The optimal effect was achieved when the length of the partition wall was twice the width of the inlet channel. Furthermore, the uniformity of velocity distribution at the inlet of the channel increased by an average of 7.4%, leading to a substantial improvement in the inlet flow regime of the pumping station. The addition of partition walls in the forebay effectively resolved the issues related to the flow regime in the forebay, providing valuable references for similar engineering studies in the future.

Study on improving flow regime in lateral inlet channel at Jinkou Pump Station

Experimental study on flow pattern in forebay pump station and rectification scheme

Numerical and Experimental Investigations of Flow Pattern and Anti-Vortex Measures of Forebay in a Multi-Unit Pumping Station

Model Test of Water Flow in Bend Chute of Spillway in Fenghuang Reservoir

Numerical Simulation of Inlet and Outlet Passages for Axial Flow Pump in Drainage Pump Station

Application and Design of an Efficient Siphon Dewatering System for Debris Flow Mitigation: A Case Study of a Small Catchment in Zhejiang Province, China

Experimental Study and Numerical Simulation of the Vertical Pipe Inlet-Outlet of Pumped Storage Plant

Influence of Partition Wall Length on Inlet Flow Regime of a Pumping Station Arranged in Parallel with a Sluice Gate

Numerical and experimental investigation on vortex control and sedimentation suppression in a Y-shaped diversion channel with circular inlet tanks

The flow patterns and sediment deposition in the forebay of a forward-intake pumping station

Three-dimensional Numerical Analysis on a New Design of Hydraulic Structure for Water Treatment

Study on flow in inlet sump of pumping station based on VOF model

Experimental Research On A Pump Suction Sump With Improved Structure

Simulation Of The Flow Condition Near The Intake Of A Pump Sump

On Improvement Laws of Flow Conditions at the Entrance of Ship Approach Channel in Narrow Continuous Meandering River by Diversion Pier

Hydraulic shape optimization on lateral inlet/outlet of pump-storage plant

Study on the Hydraulic Characteristics of Cascade Pumping Station on the East Route of South-to-North Water Diversion Project

Experimental Study and Flow Analysis on a New Design of Water-Retaining Sluice Gate

Simulation of Water Quality in a River Network with Time-Varying Lateral Inflows and Pollutants

Flow Stability Research in the Pump Sump of Large-Scale Pump Station

Study on the Hydraulic Characteristics of an Eccentric Tapering Outlet Pressure Box Culvert in a Pumping Station