Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Numerical Simulation and Experimental Investigation on Vibration Control of A Rotating Flexible Beam

A Numerically Stable Dynamic Coefficient Method and Its Application in Free Vibration of Partial-Interaction Continuous Composite Beams

Active Control on Coupled Bending-Torsion Vibration of Two-Link Space Flexible Component

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Experimental Research on Active Vibration Control of Flexible Cantilever Beam under Harmonic and Stochastic Excitation

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Vibration Control of a Smart Beam Using H8 Control

Dynamic Analysis of Rigid–Flexible Structures with Piezoelectric Actuation and Control

Multiflexoelectric Actuation and Control of Beams

Simulation and Experiment of Active Vibration Control Based on Flexible Piezoelectric MFC Composed of PZT and PI Layer

Mode Control of Vibration in Piezoelectric Cantilever Beam

An optimal vibration control strategy of AMB-flexible rotor syxstem

Stochastic Vibration Suppression Analysis of an Optimal Bounded Controlled Sandwich Beam with MR Visco-Elastomer Core

Active control of dynamic response of an adaptive beam: Modeling and experiments

Static Nano-Control Of Cantilever Beams Using The Inverse Flexoelectric Effect

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Active vibration control of a flexible beam based on experimental modal analysis

Active vibration optimal control of piezoelectric cantilever beam with uncertainties

Simulation and Experimental Research on Flexible Structure Vibration Control Based on Electromagnetic Actuator

Flap-wise Vibrations of Non-Uniform Rotating Cantilever Beams: an Investigation with Operational Experiments

Optimal Control of a Beam with Discontinuously Distributed Piezoelectric Sensors and Actuators