Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Mode Control of Vibration in Piezoelectric Cantilever Beam

Active vibration control of a cantilever beam based on neural network online identification

Active Control on Coupled Bending-Torsion Vibration of Two-Link Space Flexible Component

Active vibration optimal control of piezoelectric cantilever beam with uncertainties

Optimal Configuration of Sensors and Actuators for Vibration Control of Cantilever Plate

Adaptive modal vibration control for smart flexible beam with two piezoelectric actuators by multivariable self-tuning control

Wake Structures Of A Cantilever Beam Excited By Piezoelectric Actuators

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Vibration control of cantilever beam using poling tuned piezoelectric actuator

Active Vibration Control of Composite Cantilever Beams

Wavelet Control Model of Suppressing Vibration of Beam-Plates with Piezoelectric Sensors and Actuators

Vibration control of a rotating cantilever beam using piezoelectric actuator and feedback linearization method

Design and testing of a hybrid polymeric electrostrictive/piezoelectric beam with bang–bang control

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Vibration Control of a Smart Beam Using H8 Control

Active Vibration Control of a Piezoelectric Smart Beam Excited by the Vibration Signal of Vessel

Multiflexoelectric Actuation and Control of Beams

Simulation and Experiment of Active Vibration Control Based on Flexible Piezoelectric MFC Composed of PZT and PI Layer

Vibration suppression of a beam using variable structure control with disturbance observer

Distributed Modal Identification and Vibration Control of Continua: Piezoelectric Finite Element Formulation and Analysis