Abstract:TiO2 is regarded as a prospective electrode material owing to its excellent electrochemical properties such as the excellent cycling stability and the high safety. However, its low capacity and low electronic conductivity greatly restrict the further improvement in electrochemical performance. A new strategy was put forward to solve the above defects involved in TiO2 in which the low capacity was enhanced by nanomerization and porosity of TiO2, and the low electronic conductivity was improved by introducing Ag with a high conductivity. One-dimensional mesoporous Ag nanoparticles-embedded TiO2 nanofibers (Ag@TiO2 nanofibers) were successfully synthesized via a one-step electrospinning process combined with subsequent annealing treatment in this study. The microstructure and morphology of mesoporous TiO2@Ag nanofibers were confirmed by X-ray diffraction, scanning electron microscopy, transmission electron microscopy, and nitrogen adsorption–desorption. TiO2 nanofibers mainly consisted of a large amount of anatase TiO2, accompanied with traces of rutile TiO2. Ag nanoparticles were uniformly distributed throughout TiO2 nanofibers and promoted the transformation of TiO2 from the anatase to the rutile. The corresponding electrochemical performances are measured by galvanostatic charge-discharge, cycle stability, rate performance, cycle voltammetry, and electrochemical impedance spectroscopy measurements in this research, with pristine TiO2 nanofibers as the reference. The results indicated that the introduction of Ag nanoparticles into TiO2 nanofibers significantly improved the diffusion coefficient of Li ions (5.42 × 10−9 cm2⋅s−1 for pristine TiO2, 1.96 × 10−8 cm2⋅s−1 for Ag@TiO2), and the electronic conductivity of TiO2 (1.69 × 10−5 S⋅cm−1 for pristine TiO2, and 1.99 × 10−5 S⋅cm−1 for Ag@TiO2), based on which the comprehensive electrochemical performance were greatly enhanced. The coulombic efficiency of the Ag@TiO2 nanofibers electrode at the first three cycles was about 56%, 93%, and 96%, which was higher than that without Ag (48%, 66%, and 79%). The Ag@TiO2 nanofibers electrode exhibited a higher specific discharge capacity of about 128.23 mAh⋅g−1 when compared with that without Ag (72.76 mAh·g−1) after 100 cycles at 100 mA·g−1. With the current density sharply increased from 40 mA·g−1 to 1000 mA·g−1, the higher average discharge capacity of 56.35 mAh·g−1 was remained in the electrode with Ag, when compared with the electrode without Ag (average discharge capacity of about 12.14 mAh·g−1). When the current density was returned to 40 mA·g−1, 80.36% of the initial value was returned (about 162.25 mAh·g−1) in the electrode with Ag, which was evidently superior to that without Ag (about 86.50 mAh·g−1, only 55.42% of the initial value). One-dimensional mesoporous Ag@TiO2 nanofibers can be regarded as a potential and promising candidate as anode materials for lithium ion batteries.

Boosting the Electrochemical Performance of Li4Ti5O12 Anode Modified by Ag2V4O11

High Rate Li4Ti5O12–Fe2O3 and Li4Ti5O12–CuO Composite Anodes for Advanced Lithium Ion Batteries

Synthesis and the Improved High-Rate Performance of Limn2o4/Ag Composite Cathode for Lithium-Ion Batteries

Improving the Electrochemical Performance of Li4Ti5O12/Ag Composite by an Electroless Deposition Method

Enhanced Electrochemical Performance of a Novel Li4Ti5O12 Composite As Anode Material for Lithium-Ion Battery in a Broad Voltage Window

Solid-State Synthesis and Electrochemical Performance of Li4Ti5O12/(Ag+C)Electrode Material

Ag Embedded Li3VO4 As Superior Anode for Li-Ion Batteries

Spherical Li4Ti5O12/NiO Composite With Enhanced Capacity and Rate Performance as Anode Material for Lithium-Ion Batteries

Electrochemical Characteristics of Li4Ti5O12/Ag Composite Nanobelts Prepared Via Electrospinning

Effect of Ag Additive on the Performance of LiNi1/3Co1/3Mn1/3O2 Cathode Material for Lithium Ion Battery

Enhanced Electrochemical Performance of Li4Ti5O12 Anode for Lithium Ion Batteries with Titanate Coupling Reagent As Electrolyte Additive

Preparation and Electrochemical Performance of Ti2Nb10O29/Ag Composite as Anode Materials for Lithium Ion Batteries

Highly Dispersed Ag Nanoparticles (<10 Nm) Deposited on Nanocrystalline Li4Ti5O12 Demonstrating High-Rate Charge/discharge Capability for Lithium-Ion Battery

Solid-State Synthesis and Electrochemical Performance of Li_4Ti_5O_(12)/C(Ag+C)Electrode Material

Li4Ti5O12/TiO2 composite as anode materials for lithium ion battery

Synthesis of One-Dimensional Mesoporous Ag Nanoparticles-Modified TiO2 Nanofibers by Electrospinning for Lithium Ion Batteries

The Synergistic Effect Supported Li 4 Ti 5 O 12 Anode with Advanced Lithium Storage Performance

Improved Capacity and Rate Capability of Fe2O3 Modified Li4Ti5O12 Anode Material

Improving the Lithium Storage Properties of Li4Ti5O12 Anodes by Facile Two-Phase Formation and Nanostructure Engineering Strategy

Improvement of the High-Rate Discharge Properties of LiCoO2 with the Ag Additives

Li2ZnTi3O8@α-Fe2O3 Composite Anode Material for Li-ion Batteries