Abstract:The thermal deformation behavior of a novel TG6 titanium alloy from 850 to 1050 °C with a strain rate of 0.001-10 s−1 was studied using a Gleeble-3500 thermal simulation compressor. The constitutive model was established, then metallography was used to observe the evolution of microstructure under the influence of temperature or deformation rate, the evolution of α/β phase, and the angular distribution of grain boundaries during thermal deformation were described with the help of EBSD. The results after comprehensive analysis are as follows: TG6 titanium alloy is a strain rate and temperature-sensitive material, the flow stress increases with an increase in strain rate when the temperature is stable, and the flow stress decreases with increasing temperature at a stable strain rate. Furthermore, the flow stress increases rapidly with increase in strain in the initial stage of deformation; after reaching the maximum, it begins to decrease slowly until a relatively stable state. The morphology, size, and content of the phase can be affected by the deformation temperature and strain rate to a certain extent. The elongation and distortion of the α phase occur as the temperature falls below 950 °C and the strain rate increases above 0.01 s−1; besides, as the temperature rises near the phase transition point, the primary α phase begins to dissolve, the acicular α phase gradually precipitates from the coarse β phase and tends to continue coarsening. Finally, the combination of EBSD analysis and 3D hot processing map reveals that the dynamic recrystallization behavior is more evident at low temperatures and strain rates.

Thermal Stability of Ultrafine-Grained Pure Titanium Processed by High-Pressure Torsion

Properties of Commercial Pure Titanium under Self-Heating and High-Pressure Heating Treatment

Thermal stability of the HPT-processed tungsten at 1250 – 1350 °C

Constitutive Model and Microstructure Evolution of a Novel TG6 High-Temperature Titanium Alloy during Hot Deformation

Microstructural Evolution of Metastable Austenitic Steel During High-Pressure Torsion and Subsequent Heat Treatment

Microstructural Modification and Mechanical Improvement of Ultrafine-Grained Ti Alloy Through Electron Wind Force: an Innovative Approach

Effect of High-Pressure Torsion on Recrystallization Behavior of Pure Tungsten

In situ TEM observations of thickness effect on grain growth in pure titanium thin films

Experimental Study on Microstructure and Hardness of Pure Titanium Subjected to Torsion Deformation at Different Temperatures

Effect of Heat Treatment on Microstructure and Mechanical Behavior of Ultrafine-Grained Ti-2Fe-0.1B

On the thermal evolution of high-pressure torsion processed titanium aluminide

Microstructure Evolution during High-Pressure Torsion in a 7xxx AlZnMgZr Alloy

Microstructure evolution in ultrafine-grained interstitial free steel processed by high pressure torsion

The Determining Influence of the Phase Composition on the Mechanical Properties of Titanium-Iron Alloys after High-Pressure Torsion

Effect of composition, annealing temperature, and high pressure torsion on structure and hardness of Ti–V and Ti–V–Al alloys

Effect of High-Pressure Torsion Temperatures on the Precipitation and Properties of Cu-Cr Alloy

The Evolutions of Microstructure, Texture and Hardness of A1050 Deformed by HPT at the Transition Area

Deformation Behavior and Plastic Instabilities of Ultrafine-Grained Titanium

Microstructural Evolution and Mechanical Properties of Ultrafine‐Grained Ti Fabricated by Cryorolling and Subsequent Annealing

Phase Transformation, Microstructural Evolution and Tensile Properties of a TiH2-Based Powder Metallurgy Pure Titanium

Compressive deformation behaviors of coarse- and ultrafine-grained pure titanium at different temperatures: A comparative study