Effect of He-irradiation Fluence on the Size-Dependent Hardening and Deformation of Nanostructured Mo/Zr Multilayers
S. H. Wu,P. M. Cheng,K. Wu,Z. Q. Hou,Y. Q. Wang,X. Q. Liang,J. Li,J. Kuang,J. Y. Zhang,G. Liu,J. Sun
DOI: https://doi.org/10.1016/j.ijplas.2018.07.008
IF: 8.5
2018-01-01
International Journal of Plasticity
Abstract:Previous studies demonstrated that the He ion irradiation damage tolerance of nanostructured metallic multilayers (NMMs) was closely dependent on the layer thickness (h): smaller h led to lower irradiation hardening. Here in Mo/Zr NMMs, we uncovered that the h-dependent irradiation hardening and corresponding plastic deformation characteristics are also sensitive to the He+ irradiation fluences. At a low irradiation fluence of 1.0 x 10(16) He+.cm(-2), the irradiation hardening decreased monotonically with reducing h. While at a high irradiation fluence of 1.0 x 10(17) He+.cm(-2), a non-monotonic h-dependence was unexpectedly displayed with the minimum irradiation hardening at h of 25 run. The irradiation fluence also affects the strain rate sensitivity (m) remarkably. Irradiation of 1.0 x 10(16) He+.cm(-2) induced a transition in SRS m from positive in the as-deposited Mo/Zr NMMs to negative SRS in their irradiated counterparts. This transition was rationalized in terms of dynamic strain aging that considered dislocation bubble interactions. Irradiation of 1.0 x 10(17) He+.cm(-2), however, resulted in a non-monotonic h-dependence of m, with the bottom located at a turning point of h similar to 50 nrn. Coupling effect of the layer thickness and the applied fluence on irradiation hardening and plastic deformation characteristics was quantitatively elucidated by employing a strengthening model and a thermally activated model, respectively, where parameters of the characteristic microstructural features, ie., the layer thickness and irradiation (He) defects, were both included.