Abstract:As typical phenolic resin-based ablative materials, the high silica/phenolic and carbon/phenolic composites are widely used in aerospace field. The specific heat of the carbonized ablators after ablation is an important thermophysical parameter in the process of heat transfer, but it is rarely reported. In this investigation, the carbonized samples of the high silica/phenolic and carbon/phenolic were obtained through carbonization experiments, and the specific heat of the carbonized samples was determined by a 3D DSC from 150 \(^{\circ }\hbox {C}\) to 970 \(^{\circ }\hbox {C}\). Structural and compositional characterizations were performed to determine the mass fractions of the fiber and the carbonized product of phenolic which are the two constituents of the carbonized samples, while the specific heat of each constituent was also measured by 3D DSC. The masses of the carbonized samples were reduced when heated to a high temperature in the specific heat measurements, due to the thermal degradation of the carbonized product of phenolic resin in the carbonized samples. The raw experimental specific heat of the two carbonized samples and the carbonized product of phenolic resin was modified according to the quality changes of the carbonized samples presented by TGA results. Based on the mass fraction and the specific heat of each constituent, a weighted average method was adopted to obtain the calculated results of the carbonized samples. Due to the unconsolidated property of the fiber samples which impacts the reliability of the DSC measurement, there is a certain deviation between the experimental and calculated results of the carbonized samples. Considering the similarity of composition and structure, the data of quartz glass and graphite were used to substitute the specific heat of the high silica fiber and carbon fiber, respectively, resulting in better agreements with the experimental ones. Furthermore, the accurate specific heat of the high silica fiber and carbon fiber bundles was obtained by inversion, enabling the prediction of the specific heat of the carbonized ablators with different constituent mass fractions by means of the weighted average method in engineering.

Inverse Identification of Temperature-Dependent Thermal Conductivity for Charring Ablators

Estimation of Temperature-Dependent Thermal Conductivity and Specific Heat Capacity for Charring Ablators

Numerical analysis of ablative behavior of silicone resin coated carbon fabric

Research and Engineering Computation of Ablation Character of Carbon Phenolic Aldehyde Composite Material

Influence Factors on the Multi-Field Coupling Performances of Charring Ablators on the Basis of a Mesoscopic Ablation Model

Evaluation of Numerical Ablation Model for Charring Composites

Investigation on the Effective Thermal Conductivity of Carbonized High Silica/phenolic Ablative Material

Investigation on Thermal Conductivities of Plain-woven Carbon/Phenolic and Silica/Phenolic Composites at High Temperature: Theoretical Prediction and Experiment

Application of Levenberg–Marquardt Method for Estimation of the Thermophysical Properties and Thermal Boundary Conditions of Decomposing Materials

Novel designs of charring composites based on pore structure control and evaluation of their thermal protection performance

Combinatorial approach to predict synergistic ablation behavior of carbon fiber phenolic composites under aerodynamic loading

Effects of Pyrolysis Reaction and Gas Characteristics on the Thermal Response of Resin-Based Ablative Materials

Numerical investigation of mesoscopic volumetric ablation of 3D braided charring composites

Modeling and Validation of Ablative Thermal Response Combined with Microscopic Heat Transfer for Porous Ablative Materials

Forecasting method for ablation behaviors of carbon/phenolic composites

Design and Evaluation of Variable Porosity Charring Composite for Thermal Protection System of Reentry Vehicles

Experimental Investigation on the Specific Heat of Carbonized Phenolic Resin-Based Ablative Materials

Endothermic mechanism of silica/phenolic composite under ablative environment

An implicit coupling framework for numerical simulations between hypersonic nonequilibrium flows and charring material thermal response in the presence of ablation

Assessment of a 3D ablation material response model for lightweight quartz fiber reinforced phenolic composite

Evaluation and design methods for high‐efficiency charring composite under complex coupling mechanisms in both material and boundary layer