Abstract:Needle-free jet injection is an excellent alternative to conventional injection, which can reduce patients’ fear of needle and needle injury and reduce the probability of cross contamination. It is highly appropriate for the administration of small doses of medicines, such as vaccines and insulin. The structure of the needle-free jet injector nozzle determines the properties of the jet, and the optimized nozzle can improve injection performance. This study used the realizable k-ε turbulence model to study the effects of different nozzle cone angles and nozzle lengths on the injection effect. The peak stagnation pressure, jet velocity, and peak turbulence intensity were selected as the primary research parameters. We achieved a better nozzle structure with further analysis, and experiments were performed to verify the accuracy of the simulation model. The simulation results show that in the five nozzles with different taper settings, the nozzle with a smaller taper has higher jet velocity and peak stagnation pressure at the nozzle orifice and within a specific taper range. On the contrary, the nozzle with a smaller taper has a lower jet velocity at 4 mm away from the nozzle orifice. The effect of the nozzle length on peak stagnation pressure is limited and shows no apparent law, while the effect on the turbulence intensity is evident. The longer the nozzle length is, the less turbulence intensity is. At the same time, we also studied the influence of different viscosity liquids and different elastic coefficients of the driving spring on the injection performance. The jet impact force experiment was carried out. The results show that the simulation results are highly consistent with the experimental results, which verify the accuracy of the CFD model. The results provide ideas for optimizing the nozzle structure of commercial needle-free jet injector and help realize efficient drug delivery.

Unraveling Pre-filled Syringe Needle Clogging: Exploring a Fresh Outlook Through Innovative Techniques

Injectability of high concentrated suspensions using model microparticles

An insight of a needle free injector with magnetic material

Design and Fabrication of Tri-Axial Capillary Needles in Flow Focusing for Microencapsulation of Multiple Drugs and Imaging Agents

Contributions in Medical Needle Technologies—geometry, Mechanics, Design, and Manufacturing

Performance Improvement of an STS304-Based Dispensing Needle via Electrochemical Etching

Needle-free injection into skin and soft matter with highly focused microjets

Novel Surface Engineered Micro-Needles Towards Bio-Analytical Applications

Mechanistic Analysis of Solid–liquid Flow During Injection

Surface Finishing of Needles for High-performance Biopsy

Dynamic mechanical interaction between injection liquid and human tissue simulant induced by needle-free injection of a highly focused microjet

Investigation of swelling mechanisms in self-adherent microneedles

Numerical investigations on bubble-induced jetting and shock wave focusing: application on a needle-free injection

Simulation and experimental study on the influence of needle-free jet injection nozzle structure on injection performance

Integrating Porous Silicon Nanoneedles within Medical Devices for Nucleic Acid Nanoinjection

Porous Microneedles Through Direct Ink Drawing with Nanocomposite Inks for Transdermal Collection of Interstitial Fluid.

Needle Tip Tracking through Photoluminescence for Minimally Invasive Surgery

Focused Electron and X-ray Beam Crosslinking in Liquids for Nanoscale Hydrogels 3D Printing and Encapsulation

Design, fabrication, and penetration assessment of polymeric hollow microneedles with different geometries

Needle Labeling for Interstitial Gynecological Brachytherapy

Computational study of fluid flow in tapered orifices for needle-free injectors