Abstract:Highly viscous drugs cannot be delivered through a needle. Typically, this means that these drugs are formulated at lower concentrations, demanding higher delivery volumes, which often must be delivered intravenously. Jet injection may provide an important solution for viscous drug delivery. Jet injection is a needle-free drug delivery technique whereby a liquid drug is formed into a hair-thin (∼200 µm) high-speed (>100 m/s) jet that penetrates and delivers itself into tissue. While it may seem that it would be just as difficult to form a viscous drug into a high-speed jet as it is to force it down a needle, this is not the case. Recent work has revealed that 'viscous-heating' during jet injection can result in significant temperature increase, and resultant viscosity decrease, in a thin outer-layer of the jet; this phenomenon effectively results in the drug 'self-lubricating' as it passes through a jet injection orifice. Despite the potential for this finding to revolutionise the subcutaneous delivery of high-viscosity drugs, little further work in this area has since been reported on. In this work we develop finite element models of needle-free injection to investigate how viscous heating affects jet production, how heat exchange with the orifice material influences this process, and to what extent jet production is affected by the initial temperature of the fluid. We then conduct novel high-speed measurements of jet and orifice temperature changes due to viscous heating. We find that viscous heating is responsible for approximately doubling the speed of jets that can be produced with very viscous fluid (1 Pa·s) at room temperature. The thermal conductivity of the orifice can transfer heat away from the perimeter of the jet, and thus reduce the lubricating effect of viscous heating. We then show that by preheating 99 % glycerol (1 Pa·s) from 7 °C to 37 °C the jet speed can be increased 6-fold. We also demonstrate the successful delivery of a very viscous glycerol solution using preheated jet injection into ex vivo porcine tissue. Given that 99 % glycerol is 10- to 100-fold more viscous than current protein therapeutics, our findings demonstrate the potential for jet injection, with or without additional drug preheating, to deliver drug formulations, needle-free, that are much more viscous than those currently delivered through needles.

Fundamental Study of Electromagnetic Actuated Needle-Free Jet Injection

Conceptualisation of a novel electromechanical system for small-volume needle-free jet injection

Research on dose and depth adjustable needle-free injector

Feasibility of laser induced jets in needle free jet injections

Effect of orientation angle for needle-free jet injection

Numerical investigations on bubble-induced jetting and shock wave focusing: application on a needle-free injection

Needle-free injection into skin and soft matter with highly focused microjets

An insight of a needle free injector with magnetic material

Computational study of fluid flow in tapered orifices for needle-free injectors

Rotatable Orifice for Needle-Free Jet Injection

Simulation and experimental study on the influence of needle-free jet injection nozzle structure on injection performance

Design and simulation analysis of electric needleless syringe

Influence of input signal on injection performance for needle driven piezoelectric micro-jet device

A Needle-Free Jet Injection System for Controlled Release and Repeated Biopharmaceutical Delivery

Status and Prospect of Needle-Free Jet Injector

Investigation of Needle Motion Profile Effect on Diesel Spray in Near-Nozzle Field

Mechanistic Analysis of Solid–liquid Flow During Injection

Microfluidics control the ballistic energy of thermocavitation liquid jets for needle-free injections

Dynamic mechanical interaction between injection liquid and human tissue simulant induced by needle-free injection of a highly focused microjet

The effect of temperature-dependent drug viscosity on needle-free jet injection

Microfluidic jet impact: spreading, splashing, soft substrate deformation and injection