Abstract:Objective Single-photon detectors have the highest sensitivity of light detection. The utilization of single-photon detectors in LiDAR system can greatly improve the comprehensive performance of the system. Laser in the second near-infrared region（1.0-1.7 μm） has the advantages of high atmospheric transmittance, weak scattering and weak solar background radiation, which is the ideal working band of aerosol remote sensing and three-dimensional imaging LiDAR system. Therefore, a high-performance miniaturized free-running single-photon detector is designed in this paper.Methods The single-photon detector is based on InGaAs/InP negative feedback avalanche photodiode（NFAD）,allowing it to operate in the free-running mode（Fig.1）. A precise bias circuit and a precise temperature control circuit provide the bias voltage and cooling for the NFAD, respectively（Fig.2, Fig.3）. In order to meet the needs of photon time-of-flight measurement for LiDAR system, the time-to-digital converter（TDC） function is realized by FPGA based on carry delay chain（Fig.4）. Through the built-in micro controller unit（MCU） with integrated counting rate and afterpulse correction algorithm, it can make real-time correction of TDC data and output via USB interface.Results and Discussions The detector has dimensions of 116 mm×107.5 mm×80 mm（Fig.5）. The maximum detection efficiency is more than 35% at 1.5 μm（Fig.6）, and the time jitter（full width at half maxima, FWHM） is as low as 80 ps（Fig.7）. The time measurement accuracy of internal TDC can reach 100 ps. The miniaturized LiDAR product using this single-photon detector can detect up to 15 km with a range resolution of less than 30 m（Fig.8）.Conclusions The QCD600 series miniature free-running InGaAs/InP single-photon detector provides a compact and real-time data post-processing single-photon detection solution for LiDAR systems in the near infrared band with high efficiency, low noise, low time jitter. In the future, free-running single-photon detector will be developed in the direction of miniaturization using integrated refrigeration technology and ultra-low noise using deep refrigeration technology, which will provide more powerful technical support for LiDAR, QKD and other applications.

A new depth information detection pixel based on lateral Photodiode

Design Realization and Characterization of A Position Sensitive Detector for Fast Optical Measurement

A new depth descriptor for pedestrian detection in RGB-D images

A 16-Channel Analog CMOS SiPM with On-Chip Front-End for D-ToF LiDAR

Research on the 1D PSD

A Simple I-ToF Module Based on Avalanche Photodiode

Pixel Multiplexing Technique For Real-Time Three-Dimensional-Imaging Laser Detection And Ranging System Using Four Linear-Mode Avalanche Photodiodes

Adaptive Depth Imaging with Single-Photon Detectors

DESIGN OF A NEW DEPTH ENCODING DETECTOR FOR PET

Innovative photodetector for LIDAR systems

Low-Timing-Jitter GHz-Gated InGaAs/InP Single-Photon Avalanche Photodiode for LIDAR

Single-photon depth imaging using a photodetector with a wire-bonding quenching resistor

Simulating single-photon detector array sensors for depth imaging

Precise Detection of Two-Dimensional Displacement Based on Nonlinear Lateral Photovoltaic Effect

Two-dimension Delay-Line Microchannel Plate Imaging Detector

A 320x240 I-ToF CMOS Image Sensor with 2-Tap 5.6m Pixel and Mismatch-Nonlinearity Suppression

An Ultrasensitive Bi2O2Se/In2S3 Photodetector with Low Detection Limit and Fast Response toward High-Precision Unmanned Driving

A dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications

An 8×1k SPAD detector with TDI in 0.13μm CMOS technology

Adaptive SVM-based pixel accumulation technique for a SPAD-based lidar system

Miniaturized Free-Running InGaAs/InP Single-Photon Detector（invited） Chinese Full Text English Full Text (MT)