Abstract:Basin insulator is an important component of SF6 gas insulated switchgear (GIS), and its fault is also one of the major causes of GIS equipment failure. Due to the large capacity of high voltage power system, the faulty basin insulators are generally burned severely by the high energy arc, so the fault diagnosis is very difficult. In this paper, the surface flashover pictures of several full-scaled GIS basin insulators under impulse voltage are collected, and the morphology features of flashover traces initiating from different positions are summarized. As a result, the surface flashover patterns are divided into three types: 1) surface of shielding electrode initiated flashover, 2) triple junction initiated flashover and 3) surface of insulator initiated flashover. The inception and development process of flashover are also summarized. Besides, the diagnosis method of discharge inception position is proposed. Firstly, check the ablation points at high voltage terminal. If there is a ablation point on the surface of shielding electrode, the flashover initiates from there. If there is only ablation point at the triple junction, the inception position depends on the flashover trace morphology: when the flashover trace disperses in a single direction towards grounding electrode or high voltage electrode, the flashover initiates from the opposite triple junction; when the flashover trace disperses towards both electrodes, the flashover initiates from the insulator surface. The dispersion direction could be directly distinguished from the black carbonized dendritic traces, or from the "white dendritic traces" with the auxiliary methods. The conclusions could help the substation maintenance staff do the root cause analysis of the surface flashover, and assist the researchers in the structural optimization design of basin insulator.

Experimental Study on Flashover Performance of Hot Sticks under Switching Impulses

Flashover Discharge Model of Transmission Lines in Subsea Observation Network

Design and Performance Analysis of Multi-gap Multi-channel Spark Switch with LCR Triggered Method

Study of the flashover process on ice-covered insulator string

Analysis of the Flashover Process on Ice-covered Insulator String

Effect of a floating conductor on discharge characteristics of a long air gap under switching impulse

Experiment and Simulation of Air Gap Breakdown Characteristics Under Short-tail Impulse Waveform

Influence of temperature on developing process of surface flashover in oil-paper insulation under combined AC-DC voltage

Research on transition condition between streamer and leader in 1 m plane-rod gap under switching impulse voltage

The Development of the Streamer Discharge to Flashover along the Dielectric Surfaces

Effect of Surface Charge on Flashover Phenomena-A Dynamic Observation Using a 220 Kv Cone Spacer

Experimental Study and Analysis of Insulator Breakdown Characteristics with Short-tail Lightning Impulse

Air Breakdown in Conductor-Rod Gap with Direct or Alternating Voltage Switching Impulses

Vacuum Surface Flashover Induced by Load Current in Pulsed Power Facilities

Research on Pollution Flashover Characteristics of Hydrophilic Surface under Combined AC-DC Voltage

Study on Dynamic Flashover Model of Ice-Covered Insulator String

Impact of overvoltage on the mode transition of the spark gap switch: from edge breakdown to stochastic breakdown

Surface flashover patterns of GIS basin insulator under impulse voltage

Numerical Modeling of Different Streamer Breakdown Modes of Gas Switch under the External Circuit

Study on AC Flashover Process of Iced 110 kV Insulator Strings

Revealing the flashover mechanism of EP/GF composite insulation under DC combined harmonic voltage