Abstract:A comparative study of the essential difference,design,and application of boundary effect model (BEM) and size effect model (SEM) was conducted.SEM applies the four different multi-parameter empirical equations to the different ratio of initial crack length and specimen depth α.SEM is limited to a data-fitting function.BEM model involves the use of a unique analytical solution.On one hand,BEM can determine the material parameters-fracture toughness KIC and tensile strength f through the fitting of experimental data.On the other hand,it can establish a complete designed curve that describes the overall fracture of structure based on the identified KIC and f.The effect on three fracture controlled model (f-controlled,KIC-controlled and quasi-brittle fracture) were systematically calculated and analyzed from specimen to structure (size W=25-25000mm).The results show that linear elastic fracture mechanics (LEFM) applies for very long crack and very large structures,and there is no further need for size effect study.The size effect model is only relevant when the crack tip is close to either the front or back boundaries.The so-called "size effect" is only a special case of boundary effect.Based on the results of fracture tests (the specimen size W is 40,93,215 and 500 mm,and the ratio of initial crack length and specimen depth α is 0,0.02,0.075,0.15 and 0.3),the different combination conditions of tested data that BEM systematically studied are adopted to determine the influence law of KIC and f.The results are shown that,values are basically consistent to KIC and f,which have been determined by BEM,when the test data reaches a certain amount and one or two groups of data are removed from the overall data,either the specimens have the different W with same α=a0/W,or the same W but different α=a0/W.The studied results of this paper gave a new ideal to solve the problem that the material parameters cannot be accurately obtained using small size specimen,as well as the problem on predicting the actual structure fracture by using the material parameters.

Boundary Effect of Specimen on Fracture Energy in Concrete

Boundary Effect On The True Specific Fracture Energy Of Concreto

DETERMINATION OF BOUDNARY EFFECT ON FRACTURE ENERGY OF CONCRETE

Simplified calculation of fracture energy of concrete with consideration of boundary effect

A Mesoscopic Approach for the Size Effect on Fracture Energy of Concrete

Variation of Fracture Energy Dissipation along Evolving Fracture Process Zones in Concrete

Cohesive Cracking Simulation of Concrete Using Effective Modulus

Determination of Fracture Properties of Concrete Using Size and Boundary Effect Models

Determination of Fracture Energy of Concrete Using Wedge-Splitting Test on Compact Tension Specimens

Effect of coarse aggregate size distribution on fracture toughness of concrete based on boundary effect model

Prediction of concrete cracking behavior under different strain rates based on the boundary effects model

Numerical Experiment on Size Effect for Sfrc Splitting Fracture

Study on the Average Fracture Energy for Crack Propagation in Concrete

Experiment Studies on Fracture Energy of Cement Paste and Mortar

Determination of crack extension resistance of concrete from boundary effect model

Fracture Toughness of Ordinary Plain Concrete Under Three-Point Bending Based on Double-K and Boundary Effect Fracture Models

CONCRETE STRAIN SOFTENING CONSIDERING GLOBAL BOUNDARY CONDITIONS

DETERMINATION OF ENERGY-BASED FRACTURE PARAMETERS OF CONCRETE UNDER COMPACT TENSION

Superposition Calculation of Double-K Fracture Parameters of Concrete Using Wedge Splitting Geometry and Boundary Effect

Essential Difference and Design Application of Boundary Effect Model and Size Effect Model

Three-dimensional numerical study on mode-I local crack propagation of concrete considering boundary effect