Abstract:In view of the limitations of the current code based on the equivalent beam-column method with the “rod mode” instead of the “arch mode” for the calculation of concrete-filled steel tube arch bridges, this paper takes the real bearing mechanism of the arch as the starting point and analyzes the different bearing mechanisms of the arch and eccentric pressurized column. The concrete-filled steel tube arch model test was carried out to analyze the deformation state and damage mode, and the geometric non-linear bending moment of the measured arch was compared with the bending moment value calculated by the eccentricity increase coefficient of the “rod mode.” The results showed that the transfer of internal force is from the axial force to the arch axis, causing the vertical reaction force and horizontal thrust. However, the eccentric compression column only produced the vertical force at the bottom and combines with the lateral deformation indirectly generated by the eccentric distance. In addition, the deformation stage of the arch is basically the same as that of the eccentric compression column. The final failure mode of the arch is 4-hinge damage, and the final failure mode of the eccentric compression column is single-hinge damage. The preliminary geometric non-linear bending moment value obtained by the two modes accords well. Therefore, the main factors for the difference in the bearing mechanism between the two modes are different force structures, force transmission routes, and sources of deformation. Due to the difference in the bearing mechanism, the final failure mode is different, and the deformation ability of the arch is weakened by using the “rod mode” instead of the “arch mode.” The geometric non-linear bending moment of the control section calculated by the eccentricity increase coefficient is conservative, but the influence of the geometric non-linearity of other sections is not considered enough.

Model Test of Double-Arch Gate with Tubular Structure

Cyclic Behavior Test of a New Double-Arch Steel Gate

Application and study of a steel tubular double-arch lock

Model Designing and Static Experimental Study on Double Inner and Outer Latticed Shell String Structure

Comparison Study on Stability Behavior Between Steel Pipe Arch Bridge and CFST Truss Arch Bridge

Experimental Investigation of X-joint in Double-Arch Structure

Approach for Analyzing the Ultimate Strength of Concrete Filled Steel Tubular Arch Bridges with Stiffening Girder

Finite-element Analysis for Nonlinear Stabilities of Concrete-filled Steel Tubular Arch Bridges

STUDY FOR IN-PLANE ULTIMATE STRENGTH OF STEEL CIRCULAR ARCHES WITH HORIZONTAL SPRING SUPPORTS

THE MECHANICAL PERFORMANCE OF SINGLE DIAGONAL LACING DOUBLE-WEB STAY MEMBERS OF OPEN CONCRETE FILLED STEEL TUBES WITH FOUR MAIN ELEMENTS

Study on Material Partial Coefficients at Ultimate State of Anti-Slide Carrying Capacity of Arch Dam

Geomechanical model tests on global stability of an arch dam at Dagangshan

Experimental Study and Flow Analysis on a New Design of Water-Retaining Sluice Gate

Evaluation of Reinforcement and Analysis of Stability of a High-Arch Dam Based on Geomechanical Model Testing

Geomechanical model test for stability analysis of high arch dam based on small blocks masonry technique

Global Stability of Yangfanggou Arch Dam by 3D Nonlinear FEM Analysis and Geomechanical Model Tests

Study on the Failure Process and Nonlinear Safety of High Arch Dam and Foundation Based on Geomechanical Model Test

Model Tests and Numerical Analyses of the Nonlinear Seismic Behavior of Arch Dams with Reinforced Contraction Joints

Calculation model of concrete-filled steel tube arch bridges based on the “arch effect”

Stability Analysis for the Base Surfaces of Arch Dams by Direct Internal Force Method

Research on Hanger Force and Main Arch Stability of Long-Span Concrete-Filled Steel Tube Arch Bridge