Abstract:Parameter values adopted in railway engineering analysis at present are generally obtained through triaxial tests, whereas the remarkable difference between the actual stress path during train passage and the loading path in cyclic triaxial tests may lead to inaccurate predictions and even engineering problems. Published researches show that the actual stress path probably contains principal stress rotation(PSR), which has a sisgnificant influence on the mechanical response of soil. However, the conventional approach, i.e. cyclic triaxial test is not efficient in simulating this complicated stress path involving PSR. Instead, hollow cylinder test with cyclic shear stress has been proved to be an excellent selection for PSR study. In order to obtain reliable stress path for guiding hollow cylinder tests, three-dimensional calculation for a certain urban railway is carried out; and the distribution regularity of cyclic stress amplitudes, cycle numbers and PSR under train loads is analyzed. Furthermore, a series of cyclic torsional shear tests on hollow cylinder samples is employed to simulate the complex stress path and to research the deformation and pore pressure accumulation properties of saturated soft clay. Considering stress in foundation soil decreasing along with the depth increasing, various cyclic stress amplitudes corresponding to different depths are adopted in this experiment study. Three-dimensional calculation shows that the major principal stress axis will rotate from -90 degrees to 90 degrees during the train loading passage as well as the number and amplitude of stress waves reduce gradually with the increase of depth. It is also shown that both PSR and stress are quite sensitive to train loads as the upper soil element can identify a single wheel load while the lower soil element can just identify a bogie and even the whole train load. And through the cyclic torsional shear tests, it's obvious that the rotation of principal stress can promote the accumulation of pore pressure and strain in soft soil foundations significantly; and in the case when vertical cyclic stress amplitude equals to 15 kPa, the pore pressure and strain in cyclic torsional shear test are 77% and nearly 50% higher than that in cyclic triaxial test respectively. What's more, as the cyclic stress amplitude increases, the gap of cumulative pore pressure and strain between that two types of tests will enlarge further, which may even result in essential difference that samples in triaxial tests show only small strain whereas failure in torsional shear tests.

Analysis of Capabilities of Stress Paths of Hca to Simulate Principal Stress Rotation under Four-Direction Dynamic Loads

Analysis of Capabilities of Hca to Simulate Stress Paths for Principal Stress Rotation under Dynamic Confining Pressure

Analysis on Ability of HCA to Imitate Cyclic Principal Stress Rotation under Constant Confining Pressure

Possible Stress Path of HCA for Cyclic Principal Stress Rotation under Constant Confining Pressures

Deformation of Intact Soft Clay under Principal Stress Rotation with Effect of Intermediate Principal Stress

Impact of Shear Stress on Strain and Pore Water Pressure Behavior of Intact Soft Clay under Principal Stress Rotation

Development and application of novel hollow cylinder apparatus

Intact soft clay’s critical response to dynamic stress paths on different combinations of principal stress orientation

Microstructure Behavior Of Intact Soft Clay After Principal Stress Rotation

Research on mechanical response of soft clay under cyclic loading involving principal stress rotation

Research on Stress Path During Excavation Considering Rotation of Principal Stress Axis

Discussion on Laboratory Test Simulation of Principal Stress Axes Rotation Induced by Traffic Loading

Preliminary Study of Dynamic Testing Performance of Hollow Cylinder Apparatus

Stiffness Degradation and Plastic Strain Accumulation of Clay under Cyclic Load with Principal Stress Rotation and Deviatoric Stress Variation

Critical properties of intact soft clay under cyclic principal stress rotation

Deformation behaviors of sandy subgrade soil under traffic load-induced stress path

Experimental Study of Stress-Strain Properties of Intact Soft Clay Considering the Change of Principal Stress Direction

Deformation behavior of K0-consolidated soft clay under traffic load-induced stress paths

Influence of Initial State and Intermediate Principal Stress on Undrained Behavior of Soft Clay During Pure Principal Stress Rotation

Experimental study on non-coaxiality and influence factors of intact Hangzhou soft clay

Anisotropic and Noncoaxial Behavior of K0-Consolidated Soft Clays under Stress Paths with Principal Stress Rotation